Skip to content
Omnikalc

How much does it cost to install central air conditioning?

Enter the cooled floor area, the equipment price per ton, the installation, the ductwork, the electrical work and the permit: get the system size, the equipment cost and the total.

Updated on
Your inputs
sq ft

Value out of range

$

Value out of range

$

Value out of range

$

Value out of range

$

Value out of range

$

Value out of range

Results

Total cost

$10,600

The 600 sq ft per ton rule is only a starting point: insulation, windows, climate and ceiling height matter, so ask for a Manual J load calculation; an oversized unit cycles on and off and dehumidifies poorly
System size (tons)
3
Equipment
$4,500

This calculator gives estimates for education and planning. It is not investment, tax or legal advice; for decisions about your own situation, talk to a qualified financial professional. Central air conditioning cools the whole house through ducts. The biggest price driver is whether the home already has ductwork: adding an outdoor condenser and an indoor coil to an existing furnace is far cheaper than building a full duct system. Size matters too, and contractors size systems in tons of cooling, one ton being 12,000 BTU per hour. This calculator estimates the size from the floor area, then adds the equipment, labor, ductwork, electrical work and permit.

How the calculation works

  • System size = cooled floor area ÷ 600 sq ft per ton, rounded up
  • Equipment = system size × equipment price per ton
  • Total cost = equipment + installation labor + ductwork + electrical work + permit

A 1,800 sq ft home needs about 3 tons. At $1,500 per ton, the equipment costs $4,500. With $2,500 of labor, $3,000 of ductwork, $400 of electrical work and a $200 permit, the total is $10,600.

Typical prices

Item Typical price
Central AC with existing ducts, installed $4,000 to $8,000
Central AC with new ductwork $8,000 to $15,000
High-efficiency system (SEER2 16+) $1,000 to $3,000 more
New ductwork $2,000 to $6,000
Dedicated circuit and disconnect $300 to $1,000
Ductless mini-split, per zone $3,000 to $5,000

Sizing correctly

The 600 sq ft per ton rule is a rough starting point; homes in hot climates or with poor insulation may need one ton per 400 to 500 sq ft. An oversized unit cools quickly but shuts off before removing humidity, leaving the house clammy, while an undersized one runs nonstop. Ask the contractor for a Manual J load calculation.

Lowering the cost

Installing central air at the same time as a new furnace saves on labor and lets the coil and blower be matched. Ductless mini-splits can cost less in homes without ducts. Check for utility rebates on high-efficiency units, and seal and insulate existing ducts, since leaky ducts in an attic can waste a quarter of the cooling.

Frequently asked questions

How much does central air cost to install?

About $10,600 for a 3-ton system in a 1,800 sq ft home with new ductwork.

What size AC do I need?

Roughly one ton per 600 sq ft, but a Manual J load calculation gives the real answer.

Is central air cheaper with existing ducts?

Yes, often $4,000 to $8,000 when the ducts are already in place.

What if my house has no ducts?

Ductless mini-splits are often the cheaper option.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.