Skip to content
Omnikalc

What size chainsaw bar and notch for this tree?

Enter the trunk diameter at the cut and the height of the tree: get the minimum and standard bar length, the face notch depth, the hinge thickness and width, and the radius to keep clear.

Updated on
Your inputs
in

Value out of range

ft

Value out of range

Results

Standard bar to choose

16 in

Face notch depth (1/5 of the diameter)

2.8 in

Minimum bar length
16 in
Hinge thickness (10%)
1.4 in
Hinge width (80%)
11.2 in
Radius to keep clear (2 × height)
100 ft
Wear chainsaw protective gear, plan two escape routes, and hire a certified arborist near buildings, power lines or for leaning or damaged trees

Felling a tree with a chainsaw is one of the most dangerous jobs a homeowner can take on. Getting the basics right starts with a bar long enough for the trunk, a correctly sized face notch and a hinge that steers the tree as it falls. This calculator gives the common rules of thumb from the trunk diameter and the height of the tree; it does not replace training or a professional for anything difficult.

How the calculation works

  • Minimum bar length = trunk diameter + 2 in, so the bar reaches through in one pass
  • Standard bar = the next common bar length at or above that
  • Face notch depth = about 1/5 of the diameter (up to 1/4 at most)
  • Hinge thickness = about 10% of the diameter
  • Hinge width = about 80% of the diameter
  • Radius to keep clear = 2 × the height of the tree

For a 14 in trunk, choose at least a 16 in bar. Cut a face notch about 2.8 in deep and leave a hinge about 1.4 in thick and 11.2 in wide. For a 50 ft tree, keep everyone at least 100 ft away while it falls.

Common bar lengths

Bar Typical use
12 to 14 in pruning, small trees, light homeowner saws
16 to 18 in firewood and trees up to about 14 to 16 in
20 to 24 in larger trees, mid-size saws
28 in and more professional saws

A longer bar is harder to control and more prone to kickback, so the shortest bar that does the job is safer.

The felling cut, step by step

  1. Check the lean, the wind, dead branches and anything in the felling path.
  2. Clear two escape routes at about 45° back from the direction of fall.
  3. Cut the face notch on the side facing the fall, about 1/5 of the diameter deep.
  4. Make the back cut slightly above the bottom of the notch, leaving the hinge intact.
  5. Use wedges if needed, and walk away along an escape route as the tree starts to move.

Safety first

Wear a helmet with face screen and ear protection, chainsaw chaps or trousers, gloves and protective boots. Never work alone. Leave trees that lean heavily, are dead or damaged, or stand near buildings, roads or power lines to a certified arborist, and check local rules before cutting.

Frequently asked questions

What chainsaw bar length for a 14 in tree?

At least 16 in: the diameter plus 2 in.

How deep should a felling notch be?

About 1/5 of the trunk diameter, up to 1/4 at most: 2.8 in for a 14 in trunk.

How thick should the hinge be?

About 10% of the diameter: 1.4 in for a 14 in trunk.

How far away should people stand when felling a tree?

At least twice the tree's height: 100 ft for a 50 ft tree.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.