Skip to content
Omnikalc

How much does a ductless mini-split cost?

Enter the number of heads, the installed prices, the electrical work, the rebates, the capacity, the efficiency and your electricity price: get the installed cost, the cost per head, the running cost and the 10-year total.

Updated on
Your inputs

Value out of range

$

Value out of range

$

Value out of range

$

Value out of range

$

Value out of range

$

Value out of range

BTU/h

Value out of range

h

Value out of range

Value out of range

$ /kWh

Value out of range

Results

Installed cost after rebates

$6,700

Running cost per year

$245

A mini-split can heat as well as cool; heating-season efficiency (HSPF2) is lower than cooling SEER2, and very cold climates need a cold-climate model rated for low temperatures
Cost per head
$3,350
Electricity used per year
1,440 kWh
Total over 10 years (installation plus electricity)
$9,148

A ductless mini-split is an air conditioner and heat pump that connects an outdoor unit to one or more wall-mounted indoor units through a small line set, with no ducts. It suits additions, garages, converted attics and older homes with no ductwork. This calculator adds up the installation cost of your system, subtracts any rebates, estimates the electricity it uses in a year and gives the total cost over 10 years.

How the calculation works

  • Installed cost = outdoor unit and first head + (heads − 1) × additional head + electrical + extras − rebates
  • Cost per head = installed cost ÷ heads
  • Electricity per year = capacity in BTU/h × full-load hours ÷ efficiency (SEER2) ÷ 1,000
  • Running cost = electricity per year × price per kWh
  • 10-year total = installed cost + 10 × running cost

Example

You install a two-head system. The outdoor unit with the first head costs $4,000, the second head $1,800, electrical work $600 and extras $300: $6,700, or $3,350 per head. A 24,000 BTU/h system running the equivalent of 1,200 hours at full load with an efficiency of 20 uses about 1,440 kWh a year. At $0.17 per kWh, that is about $245 a year, and the 10-year total is about $9,150.

What drives the price

The biggest factors are the number of heads, the capacity, the brand and efficiency, and how hard the installation is. A long line set, drilling through masonry, a second-story outdoor unit or a new electrical circuit all add labor. Multi-zone systems share one outdoor unit, which costs less than separate systems but ties every room to the same unit. Ask for a load calculation instead of sizing by rule of thumb: an oversized unit short-cycles and removes less humidity.

Saving on a mini-split

Federal tax credits for efficient heat pumps ended for equipment installed after 2025, but many utilities, states and local programs still offer rebates, so check what is available where you live. Choosing a higher-efficiency model costs more up front but cuts the electricity bill every year, and the calculator lets you compare. Cleaning the filters monthly and having the system serviced once a year keeps it efficient.

Frequently asked questions

How much does a ductless mini-split cost?

Typically $3,000 to $5,000 for a single zone installed and $6,000 to $14,000 for a multi-zone system.

Is a mini-split cheaper to run than central air?

Often yes: no duct losses and higher efficiency, which can save 20% to 40%.

How many BTU do I need?

About 20 BTU per square foot in a typical room, adjusted for sun, insulation and ceiling height.

Does a mini-split need a permit?

Usually yes for the electrical work, and some places require a licensed installer.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.