Skip to content
Omnikalc

How much screen do you need to enclose a porch?

Enter the porch length along the house, the porch depth, the wall height, the door width, the screen roll width and length, and the post spacing: get the open length to screen on three sides, the screen area with 10% waste, the rolls and the posts.

Updated on
Your inputs
ft

Value out of range

ft

Value out of range

ft

Value out of range

ft

Value out of range

ft

Value out of range

ft

Value out of range

ft

Value out of range

Results

Screen area with 10% waste

326 sq ft

Screen rolls

1

Open length to screen
37 ft
Posts, corners included
8
Fiberglass screen is cheap and easy to install, while pet-resistant or solar screen costs more; add a kick plate or knee wall at the bottom where pets and feet push on the screen, and check whether enclosing a porch needs a permit

Screening a covered porch keeps out mosquitoes, flies and falling leaves while letting the breeze through, and it turns the porch into a room you can use all summer. The main supplies are screen fabric, the framing posts that divide the openings, and spline or trim to hold the screen. This calculator works out the open length to screen, the screen area, the rolls to buy and the posts.

How the calculation works

  • Run around the porch = 2 × depth + length along the house, since the house wall closes the fourth side
  • Open length to screen = run − door width
  • Screen area = open length × wall height × 1.1 for waste and overlaps
  • Rolls = screen area ÷ (roll width × roll length), rounded up
  • Posts = run ÷ post spacing, rounded up, + 1

A 16 × 12 ft porch has a run of 40 ft on its three open sides. Minus a 3 ft door, that leaves 37 ft to screen. With 8 ft walls and 10% waste, you need about 326 sq ft of screen, which fits on one roll 4 ft wide and 100 ft long. Posts every 6 ft take 8 posts, corners included.

Choosing the screen

Screen Good for
Standard fiberglass lowest cost, easy to install, does not dent
Aluminum stiffer and longer lasting, can dent
Pet-resistant thick vinyl-coated mesh that resists claws
Solar or shade screen blocks part of the sun and heat
Fine mesh, 20 × 20 keeps out tiny biting insects such as no-see-ums

Building tips

  • Divide large openings with posts or horizontal rails so the screen stays tight and is easy to replace.
  • A kick plate or a short knee wall at the bottom protects the screen from feet, toys and pets.
  • Use a screen door with a closer that swings out, so it does not take room inside.
  • Seal gaps at the floor and ceiling, where insects get in most often.

Before you start

Enclosing a porch can change how your home is classified and may need a building permit, especially with a new roof or electrical work. Check with your local building department and your homeowners association.

Frequently asked questions

How much screen do I need for a porch?

About 326 sq ft for a 16 × 12 ft porch with 8 ft walls and a 3 ft door, 10% waste included.

How many rolls of screen do I need?

One 4 × 100 ft roll covers the 326 sq ft of a 16 × 12 ft porch.

How far apart should screen porch posts be?

About 4 to 6 ft, so the screen stays tight and panels are easy to replace.

Which screen is best for a porch with pets?

Pet-resistant vinyl-coated mesh, often combined with a kick plate at the bottom.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.