Skip to content
Omnikalc

What ground resolution will your drone camera give?

Enter the sensor width, focal length, image size, altitude and overlaps: get the ground sample distance, the footprint of one photo, the spacing of photos and lines and the altitude for a target resolution.

Updated on
Your inputs
mm

Value out of range

mm

Value out of range

px

Value out of range

px

Value out of range

Value out of range

%

Value out of range

%

Value out of range

cm/px

Value out of range

Results

Ground sample distance (GSD)

2.74 cm/px

Fine detail, suited to detailed mapping and agriculture

Altitude needed for the target resolution

73 m

Ground footprint width
150.0 m
Ground footprint height
100.0 m
Area covered by one photo
1.50 ha
Distance between photos along the line
25.0 m
Distance between flight lines
52.5 m

The ground sample distance (GSD) is the size on the ground of one pixel of an aerial photo. It tells you how much detail a drone or aircraft camera can capture from a given height, and so how finely you can map, measure or inspect. This calculator works from your camera’s sensor and lens, derives the GSD and the ground footprint of one picture, and plans the spacing between photos and flight lines for the overlap you want.

How the calculation works

  • GSD = sensor width × altitude ÷ (focal length × image width in pixels), converted to cm per pixel
  • Footprint = GSD × number of pixels, in width and in height
  • Spacing between photos = footprint height × (1 − forward overlap)
  • Spacing between lines = footprint width × (1 − side overlap)
  • Altitude for a target GSD = target × focal length × image width ÷ sensor width

Example

A camera with a 13.2 mm sensor, an 8.8 mm lens and 5,472 × 3,648 pixels, flying at 100 m, gives a GSD of 2.74 cm/px. One photo covers 150 m × 100 m, or 1.5 ha. With 75% forward overlap, photos are taken every 25 m, and with 65% side overlap the lines are 52.5 m apart. To reach 2 cm/px, you would fly at about 73 m.

Choosing the resolution

Set the GSD from the smallest feature you need to see: a rule of thumb is that an object must cover at least 3 to 5 pixels to be recognized. Lowering the altitude improves detail but multiplies the number of photos and flights, since the footprint shrinks with the square of the altitude.

Practical points

Keep the altitude constant above the ground, not above the take-off point, over uneven terrain. Higher overlaps help in vegetation and uniform fields. Check that the shutter speed is fast enough to avoid motion blur, which at 5 m/s and a 2.7 cm GSD should be below about 1/500 s.

Frequently asked questions

What is the ground sample distance?

The distance on the ground between the centers of two adjacent pixels in an image. Smaller means finer detail.

What is a good GSD for mapping?

2 to 3 cm per pixel suits detailed drone surveys; 5 cm or more is enough for large areas where fine detail is not required.

How much overlap do I need?

Typically 75% to 80% along the flight line and 60% to 70% between lines for good photogrammetry.

Does flying higher always lower quality?

It increases the GSD, which gives less detail, but it covers more ground per photo and shortens the flight.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.