Every spring, sugar maples can be tapped for sap, which is boiled down into syrup. The sap is mostly water, so the main question is how much sap you need and how long you will boil. This calculator uses the classic rule of 86.
The rule of 86
The rule of 86 estimates how many units of sap make one unit of syrup: divide 86 by the sap’s sugar percentage. Sugar maple sap averages about 2%, so 86 ÷ 2 = 43 gallons of sap make 1 gallon of syrup. Sweeter sap at 3% needs only about 29 gallons; red and silver maples, often around 1.5%, need about 57. Measure sugar content with a sap hydrometer or a refractometer.
How much sap will my taps give?
A healthy tap on a mature sugar maple produces about 10 gallons of sap in a typical season, often between 5 and 15 depending on weather. The best runs come with freezing nights and thawing days. Ten taps at 10 gallons each give 100 gallons of sap, about 2.3 gallons of syrup.
Tapping guidelines suggest one tap for trees about 10 to 20 in in diameter and two for larger trees. Trees smaller than about 10 in should not be tapped.
Boiling off the water
Making 2.3 gallons of syrup means evaporating about 98 gallons of water. On a backyard pan that boils off 2 gallons an hour, that is about 49 hours of boiling over the season. Larger flat pans and arch evaporators boil faster; a kitchen stove is far too slow for more than a small batch, and the steam can damage walls and ceilings.
When is it syrup?
Syrup is done at about 66 to 67 °Brix, or about 7 °F above the boiling point of water at your location. Underboiled syrup ferments; overboiled syrup crystallizes. Filter it hot to remove sugar sand, and bottle it hot, at about 180 °F, in clean containers.
Tips
- Collect and boil sap quickly; it spoils within days in warm weather.
- Keep collected sap cold, ideally below 38 °F.
- Pull taps at the end of the season so the holes can heal.