Skip to content
Omnikalc

Winch size calculator: what rating does your 4x4 need?

Enter the loaded weight, the slope and the ground to get the line pull for a recovery, the rule-of-thumb rating and the recommended winch size.

Updated on
Your inputs

Value out of range

%

Value out of range

Results

Recommended winch rating

9,000 lb

Line pull needed for the recovery
2,077 lb
Rule-of-thumb rating (1.5 × weight)
9,000 lb
Pull per line with a snatch block
1,038 lb

A winch that is too small fails when you need it, and one that is too large costs more and weighs more. This winch size calculator takes the loaded weight of your vehicle, the slope and the ground to give the line pull needed for a recovery, the rule-of-thumb rating, the recommended winch rating and the pull per line with a snatch block.

How the calculation works

  • Line pull needed = vehicle weight × (rolling resistance + sine of the slope angle). The first term is the resistance of the ground, and the second the part of the weight that pulls the vehicle back down the slope.
  • Rule of thumb: choose a winch rated at 1.5 times the loaded weight of the vehicle, which leaves room for mud, a hard-to-move load and cable losses.
  • Recommended rating is the higher of the rule of thumb and 1.25 times the line pull calculated for the recovery.
  • A snatch block doubles the lines, so the pull on each line is about half, and the load on the winch is cut by the same amount.

Example

A truck weighs 6,000 lb loaded and is stuck in sand (resistance 0.15) on a 20% slope. The slope angle has a sine of 0.196, so the line pull is 6,000 × (0.15 + 0.196) = 2,077 lb. The rule of thumb gives 1.5 × 6,000 = 9,000 lb, which is also the recommended rating. With a snatch block, the pull on each line is about 1,038 lb.

Why it matters

Off-road drivers, farmers and tow operators use the figures to choose a winch before they buy, and to know whether the one they own can recover a given load. The calculation also shows the benefit of a snatch block on a hard recovery.

Good to know

The line pull is an estimate for a steady pull on a uniform slope. A vehicle that is sunk, high-centered or held by an obstacle needs much more than the formula shows, and shock loads from a jerk on the cable can double the force. The rating of the winch is for the first layer on the drum. Follow the manufacturer’s instructions, use rated recovery gear and do not rely on this tool for safety.

The towing capacity calculator checks what a vehicle can pull, the vehicle payload calculator counts the load it can carry and the tire size calculator compares tire dimensions.

Frequently asked questions

How big should my winch be?

The common rule is a winch rated at 1.5 times the gross weight of the vehicle, with the weight of gear, passengers and fuel included. A 6,000 lb truck is then matched with a 9,000 lb winch. A larger winch gives a margin for deep mud and for a vehicle that sinks, and the calculator checks the pull for the slope and ground.

What is rolling resistance?

It is the force, as a fraction of the weight, that the ground opposes to the vehicle moving. Pavement is about 0.02, gravel 0.05, sand 0.15 and deep mud or snow 0.3 or more. A vehicle sunk to its axles can need more than the tables show.

Why use a snatch block?

A snatch block is a pulley that turns the cable back to the vehicle, so two lines share the load. This halves the pull on the winch and the line, and it doubles the length of cable that you need. It also doubles the time to pull, since the line speed on the vehicle is halved.

What are the safety limits?

Never exceed the rating of the winch, the cable, the hooks, the shackles and the anchor point. Use a damper over the line, keep bystanders well clear and wear gloves. The rating applies to the first layer of cable on the drum, and the pull available falls with each added layer.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.