Skip to content
Omnikalc

Bioavailability calculator: what fraction of a dose reaches the bloodstream?

Enter the AUC and dose of a tested route and of a reference to get the bioavailability, the exposure per mg and the dose that matches the reference.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs

Value out of range

Value out of range

Value out of range

Value out of range

Results

Bioavailability F relative to the reference

58.3 %

AUC per mg, tested route
0.420
AUC per mg, reference
0.720
Tested dose needed to match the reference AUC (mg)
85.7
Share of the dose lost before reaching the blood
41.7 %

This calculator is for general information and education. It is not medical advice and does not replace the advice of your doctor or a registered dietitian.

Bioavailability describes how much of a drug dose actually reaches the blood. The bioavailability calculator takes the AUC and dose of a tested route or formulation and the AUC and dose of a reference, and gives the bioavailability F, the exposure per mg of each, the dose needed to match the reference and the share of the dose lost before it reaches the circulation.

How the calculation works

  • Measure the area under the concentration-time curve (AUC) after giving the tested route or formulation, for example an oral tablet, and after the reference, usually an intravenous dose.
  • Divide each AUC by its dose to get the exposure per mg: AUC ÷ dose. A route that delivers the drug more completely gives more AUC per mg.
  • Bioavailability F = (AUC test ÷ dose test) ÷ (AUC reference ÷ dose reference). With an intravenous reference, which is 100 % available by definition, this is the absolute bioavailability.
  • The dose needed to match the reference AUC is the test dose × AUC reference ÷ AUC test. Two formulations are usually called bioequivalent when the ratio of their exposures lies within 80 % to 125 %.

Example

A 100 mg oral tablet gives an AUC of 42 mg·h/L. A 50 mg intravenous dose gives 36 mg·h/L. The exposure per mg is 0.42 by mouth and 0.72 intravenously, so F = 0.42 ÷ 0.72 = 58.3 %. To reach the AUC of the 50 mg injection by mouth, the dose would have to be 85.7 mg, and about 41.7 % of an oral dose never reaches the blood.

Why it matters

Dose conversions between routes, from injection to tablet or from brand to generic, depend on bioavailability. Pharmacy students and researchers use the ratio to interpret studies, and it explains why an oral dose is often higher than an intravenous one.

Good to know

The calculation assumes that the drug follows linear pharmacokinetics, that the AUC is measured to infinity or over the same period for both routes, and that clearance is the same on both occasions. It is educational, and it does not replace the advice of a doctor or pharmacist about any real dose.

The half-life calculator follows how a drug falls over time, and the creatinine clearance calculator estimates kidney function, which affects the dose.

Frequently asked questions

What is bioavailability?

It is the fraction of an administered dose that reaches the systemic circulation unchanged. An intravenous dose has a bioavailability of 100 %, while an oral dose can have much less because it is only partly absorbed or is broken down in the gut wall and the liver before it enters the general circulation.

What is the difference between absolute and relative bioavailability?

Absolute bioavailability compares a route with an intravenous dose of the same drug. Relative bioavailability compares two formulations or routes without an intravenous reference, for example a generic tablet and the brand tablet, and its value can exceed 100 %.

Why divide the AUC by the dose?

The AUC rises with the dose, so doses of different sizes cannot be compared directly. Dividing by the dose gives the exposure per unit of drug, which makes the two routes comparable even if the amounts given were not the same.

Can the dose be changed to match the exposure?

In simple linear pharmacokinetics, yes: the exposure scales with the dose, so the dose that matches a reference AUC follows from the ratio. Real drugs may be nonlinear, with saturable absorption or metabolism, and then the result is only an estimate to discuss with a pharmacist.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.