Skip to content
Omnikalc

FEUrea calculator: prerenal or intrinsic kidney injury?

Enter the urine and blood urea and creatinine to get the fractional excretion of urea, with the 35 % and 50 % cut-offs that separate prerenal from intrinsic causes.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs
mg/dL

Value out of range

mg/dL

Value out of range

mg/dL

Value out of range

mg/dL

Value out of range

Results

Fractional excretion of urea (FEUrea)

31.3%

Below 35 %: prerenal pattern (low kidney perfusion)
Urine to blood urea ratio
12.5
Urine to serum creatinine ratio
40.0

This calculator is for general information and education. It is not medical advice and does not replace the advice of your doctor or a registered dietitian.

When kidney function drops suddenly, one question comes first: is the kidney under-filled or is it damaged? The fractional excretion of urea helps answer it. This FEUrea calculator uses urine and blood urea and urine and serum creatinine to give the percentage of filtered urea that is excreted, and compares it with the usual 35 % and 50 % cut-offs.

How the calculation works

  • FEUrea = (urine urea × serum creatinine) ÷ (blood urea × urine creatinine) × 100.
  • Use the same unit for both urea values and the same unit for both creatinine values. The ratio does not depend on the unit, so urea nitrogen (BUN) can stand in for urea.
  • Below 35 % points to a prerenal state, such as dehydration, heart failure or cirrhosis, where the kidney holds on to urea.
  • Above 50 % points to an intrinsic kidney cause, such as acute tubular necrosis. The range from 35 to 50 % is indeterminate.
  • Why not use FENa: a diuretic raises the sodium excreted but has little effect on urea, so FEUrea stays useful in patients who have taken a diuretic.

Example

A patient with acute kidney injury has urine urea nitrogen of 500 mg/dL, BUN of 40 mg/dL, urine creatinine of 80 mg/dL and serum creatinine of 2.0 mg/dL. FEUrea = (500 × 2) ÷ (40 × 80) × 100 = 31.2 %. That is below 35 %, a prerenal pattern, which fits a kidney that is under-perfused rather than damaged. The urine to blood urea ratio is 12.5 and the creatinine ratio is 40.

Why it matters

Separating a prerenal state from an intrinsic injury changes treatment: the first usually responds to fluids or to treating the cause of low perfusion, while the second needs a different approach. FENa is the classic index, but it becomes unreliable after diuretics, and that is exactly when FEUrea is most useful.

Good to know

Like all urinary indices, FEUrea works best when urine is collected as a spot sample at the same time as the blood draw and when the picture is that of oliguric acute kidney injury. Chronic kidney disease, sepsis, contrast, very high urea production and recent urea or high-protein feeding can all distort the value. Treat the result as one clue among several: the history, the volume status, the urine sediment and the response to treatment matter more than any single number.

The FENa calculator is the sodium version of this index, the BUN to creatinine ratio calculator is a quick bedside clue and the urine anion gap calculator checks how the kidney handles acid.

Frequently asked questions

What does FEUrea measure?

It is the share of the filtered urea that ends up in the urine. In a prerenal state the tubules reabsorb most of the urea along with water, so little is excreted and the value is low.

When is FEUrea better than FENa?

When the patient has taken a loop or thiazide diuretic, because the diuretic pushes sodium into the urine and makes FENa look high even in a dry patient. Urea excretion changes much less.

What are the cut-offs?

Below 35 % suggests a prerenal cause and above 50 % an intrinsic one. Between the two the result is indeterminate and has to be read with the clinical picture.

Can I mix units?

Use the same unit for the urea in urine and in blood, and the same unit for the creatinine in both. The units cancel out, so mg/dL, mmol/L and µmol/L all work as long as each pair matches.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.