Skip to content
Omnikalc

Jackson-Pollock 3-site skinfold body fat calculator

Enter your sex, age, weight and three skinfold thicknesses to get the sum of skinfolds, the body density, the Siri body fat percentage, the fat mass and the lean mass, with the category of the American Council on Exercise.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs
years

Value out of range

kg

Value out of range

mm

Value out of range

mm

Value out of range

mm

Value out of range

Results

Body fat percentage (Siri)

16.2 %

Fitness range for men (ACE: 14 to 17 %)
Sum of the three skinfolds
52 mm
Body density
1.0617 g/cm³
Fat mass
13.0 kg
Lean mass
67.0 kg

The Jackson-Pollock skinfold body fat calculator gives the body density, the body fat percentage by the Siri equation, the fat mass and the lean mass from three skinfold measurements with calipers, the age and the sex.

How the calculation works

  • Choose the sex, then enter the age and the weight.
  • Enter the three skinfolds in millimeters.
  • Read the body fat percentage and the category.

Example

A man aged 35 weighing 80 kg has skinfolds of 12 mm (chest), 22 mm (abdomen) and 18 mm (thigh), a sum of 52 mm. The body density is 1.10938 − 0.0008267 × 52 + 0.0000016 × 52² − 0.0002574 × 35 = 1.0617 g/cm³, so the Siri body fat is 495 / 1.0617 − 450 = 16.2 %. This is 13.0 kg of fat and 67.0 kg of lean mass, in the fitness range for a man.

Why it matters

The calculator helps personal trainers, dietitians, sport science students and fitness enthusiasts who own a skinfold caliper and want an estimate of body composition that is more specific than the body mass index.

Good to know

Skinfold methods rely on the fact that about half of the body fat is stored just under the skin and that its thickness is correlated with the total fat. The Jackson-Pollock equations were derived on young and middle-aged adults of normal weight, so they are less reliable for very lean athletes, for very heavy people, for older adults and for different ethnic groups. Take each measurement three times, on the right side, and use the median, with the person relaxed, before exercise, because blood flow to the skin changes the thickness. The reading is taken after about two seconds of pressure on the fold. The body fat percentage is not a measure of health by itself, and the ranges used here are the categories published by the American Council on Exercise, which are descriptive. A more accurate measurement of body composition requires methods such as dual-energy X-ray absorptiometry, underwater weighing or air displacement plethysmography.

The lean body mass calculator uses weight and height, the body fat calculator uses tape measurements, the BMI calculator is the screening index and the vertical jump calculator treats the power of the legs.

Frequently asked questions

What is the Jackson-Pollock method?

It estimates the body density from the sum of skinfolds measured with calipers at 3 or 7 sites, corrected for age, using a quadratic equation by sex. The density is then converted into a body fat percentage with the Siri equation: 495 / density − 450.

Where are the skinfolds measured?

For men: the chest (halfway between the nipple and the armpit), the abdomen (2 cm to the side of the navel) and the thigh (halfway between the hip and the knee). For women: the triceps, the suprailiac (above the hip bone) and the thigh. All on the right side, with a vertical or diagonal fold as defined.

How accurate is it?

The standard error is about 3 to 4 percentage points of body fat when the measurements are taken by a trained person. Errors on caliper placement and fold pressure are the main causes, so use the same person and the same caliper to follow changes over time.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.