Skip to content
Omnikalc

Overjet and overbite assessment calculator

Enter the overjet, the overbite and the height of the lower incisor crown to get the overbite as a percentage of the crown, and the classification of the horizontal and vertical relationship of the incisors.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs
mm

Value out of range

mm

Value out of range

mm

Value out of range

Results

Overbite as a percentage of the lower incisor crown

35 %

A normal overbite (20 to 50 % of the crown)
Classification of the overjet
3.0 mm
A normal overjet (1 to 3.5 mm)
Overbite in millimeters beyond the normal maximum (50 % of the crown)
0.0 mm

The overjet and overbite calculator gives the overbite as a percentage of the lower incisor crown and classifies the overjet and the overbite of the incisor relationship from the horizontal and vertical measurements.

How the calculation works

  • Enter the overjet in millimeters.
  • Enter the overbite and the crown height of the lower incisor.
  • Read the percentage and the classification.

Example

An overjet of 3 mm is within the normal range of 1 to 3.5 mm. An overbite of 3 mm on a lower incisor crown of 8.5 mm is 3 / 8.5 = 35 % of the crown, which is also normal (20 to 50 %). The bite is therefore a normal incisor relationship in both directions.

Why it matters

The calculator helps dental and orthodontic students, dental assistants, dentists and parents who read an orthodontic record and want to understand what the numbers describe.

Good to know

Overjet is measured with a ruler held parallel to the occlusal plane, from the labial surface of the lower incisor to the edge of the upper incisor, while the patient bites in the position of maximal intercuspation. Overbite is measured by marking on the lower incisor the line of the upper incisor edge, and measuring the distance of the line to the lower incisal edge. The two are different dimensions and a patient may have a large overjet with a shallow overbite, or the opposite. The incisor classification of the British Standards Institute describes Class I, Class II divisions 1 and 2, and Class III by the position of the lower incisor edge relative to the cingulum plateau of the upper incisor, not by the numbers alone. An increased overjet increases the risk of damage to the upper incisors in a fall, and a reversed overjet may need early treatment. The numbers do not decide the treatment, which also depends on age, growth, profile and jaw relationship.

The Bolton calculator treats tooth size ratios, the arch length calculator treats crowding, the mouth opening calculator treats the jaw joint and the braces cost calculator covers the cost of treatment.

Frequently asked questions

What are overjet and overbite?

The overjet is the horizontal distance between the edges of the upper and lower front teeth. The overbite is the vertical overlap of the upper incisors over the lower ones, which can also be given as a percentage of the lower crown height.

What are the normal values?

A normal overjet is 2 to 3 mm and an overbite is 2 to 4 mm, or 20 to 50 % of the lower crown. A larger overjet is common in Class II malocclusions, and a negative one in Class III malocclusions.

Why measure them?

They are used to diagnose the type of malocclusion, to assess the risk of trauma, to plan the treatment and to follow progress. A deep overbite can also wear the lower incisors or irritate the gum.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.