Skip to content
Omnikalc

How effective is a contraceptive method in a study?

Enter the pregnancies observed, the number of women and the months each was followed: get the Pearl Index, the total exposure in woman-years and the share of women who became pregnant.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs

Value out of range

Value out of range

Value out of range

Results

Pearl Index (pregnancies per 100 woman-years)

0.60

Very effective: fewer than 1 pregnancy per 100 woman-years
Total exposure
500 woman-years
Share of women who became pregnant during follow-up
0.60%

The Pearl Index is the traditional way to express how well a contraceptive method works. It counts the pregnancies that occurred for every 100 women who used the method for one year. A lower value means a more effective method. Studies of contraceptives often report it, and you can compute it from the number of pregnancies, the number of women and how long they were followed.

How the calculation works

  • Total exposure = number of women × months of follow-up
  • Pearl Index = pregnancies × 1,200 ÷ total months of exposure
  • Equivalent: pregnancies × 100 ÷ woman-years

The index is a rate, not the probability of becoming pregnant in a given year, although the two are close when the rate is low.

Example

In a study of 500 women followed for 12 months each, 3 pregnancies occur. The total exposure is 6,000 months, or 500 woman-years. The Pearl Index is 3 × 1,200 ÷ 6,000 = 0.6: about 0.6 pregnancies per 100 women per year of use, a very effective method.

Perfect and typical use

A study may report the index for perfect use (the method used correctly every time) and for typical use (including mistakes). The difference is large for methods that depend on the user, such as the pill, condoms or fertility awareness, and small for those that do not, such as implants and IUDs.

Limits and cautions

The Pearl Index assumes the risk of pregnancy stays constant, which is rarely true. It also depends on who is in the study: age, fertility and how long they have been using the method all matter. Compare indexes only across similar studies, and discuss the right method for you with a health professional.

Other ways to express effectiveness

Studies also report the percentage of women who become pregnant during the first year, using life-table methods that account for dropouts. These probabilities are slightly lower than the Pearl Index at high failure rates. Ask which measure a figure uses before comparing two methods.

Frequently asked questions

What is the Pearl Index?

A measure of contraceptive failure: the number of pregnancies per 100 woman-years of use.

How is it calculated?

Pregnancies × 1,200 ÷ total months of exposure. This equals pregnancies × 100 ÷ woman-years.

What are typical values?

Under 1 for implants, IUDs and consistent use of the pill; around 10 to 20 for condoms in typical use; about 85 with no contraception.

What are its limits?

It assumes a constant risk over time, but pregnancies cluster early, so it can overstate effectiveness in long studies. Life-table methods are more accurate.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.