Skip to content
Omnikalc

What size bit does my horse need?

Enter the width of the horse's mouth at the corners of the lips and the type of bit: get the mouthpiece size to buy, the size in the other unit and the room on each side.

Updated on
Your inputs
in

Value out of range

Results

Bit size to buy

5.50 in

Full or horse size range
Bit size in centimeters
14.0 cm
Room on each side
0.30 in
Check the fit on the horse: a snaffle should make one or two soft wrinkles at the corners of the mouth, and you should fit about a finger's width between the ring and the lips

A bit that is too narrow pinches the corners of the horse’s mouth, and one that is too wide slides from side to side and acts unevenly. The right size depends on the width of the mouth and on the type of bit. This calculator turns the mouth measurement into a size to buy, in inches and centimeters.

How the calculation works

  • Bit size = mouth width + allowance for the bit type, rounded up to the next size step
  • Room on each side = (bit size − mouth width) ÷ 2
Bit type Allowance
Loose ring snaffle 1/2 in in total
Fixed cheek: eggbutt, D-ring, full cheek 1/4 in in total
Curb, pelham, kimberwick snug fit

US bits come in 1/4 in steps. A horse whose mouth measures 4.9 in across needs a loose ring snaffle of at least 5.4 in, so you buy a 5.5 in bit, about 14.0 cm. That leaves 0.30 in on each side, so the rings move freely without pinching the lips.

How to measure

  • Use a bit measure or a piece of string with a knot at one end, or a wooden dowel.
  • Slide it into the mouth where the bit sits, across the bars.
  • Mark the width at the corners of the lips on both sides and measure between the marks.

Typical sizes

Size Usual range
Pony 4 to 4.75 in
Cob or Arab 5 to 5.25 in
Average horse 5.5 to 5.75 in
Warmblood or draft 6 in or more

Checking the fit

  • A snaffle should make one or two soft wrinkles at the corners of the mouth.
  • There should be room for about a finger’s width between the ring and the lips.
  • The thickness of the mouthpiece matters too: horses with a low palate or a thick tongue are often more comfortable with a thinner bit.
  • Check the teeth regularly; sharp edges or wolf teeth make any bit uncomfortable.

Frequently asked questions

How do I measure a horse for a bit?

Slide a bit measure or knotted string into the mouth where the bit sits and measure between the corners of the lips.

What size bit for a 4.9 in mouth?

A 5.5 in loose ring snaffle, about 14.0 cm, leaving 0.30 in on each side.

Should a loose ring bit be bigger than an eggbutt?

Yes, allow about 1/2 in in total for a loose ring and 1/4 in for a fixed cheek so the rings do not pinch.

How do I know if a bit fits?

A snaffle should make one or two soft wrinkles at the corners of the mouth, with about a finger's width between ring and lips.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.