Skip to content
Omnikalc

Baryonic Tully-Fisher calculator

Enter the flat rotation speed of a spiral galaxy, its gas fraction and a radius to get the baryonic mass from the Tully-Fisher relation, the stellar mass, the dynamical mass inside the radius and the baryon share of that mass.

Updated on
Your inputs
km/s

Value out of range

%

Value out of range

kpc

Value out of range

Results

Baryonic mass (billions of solar masses)

110.10 G☉

Stellar mass (billions of solar masses)

99.09 G☉

Gas mass (billions of solar masses)
11.01 G☉
Dynamical mass inside the radius
337.60 G☉
Baryon share of the dynamical mass
32.6 %
Mass factor if the speed doubled
16
Mass compared with the Milky Way (about 60 billion)
1.84

The baryonic Tully-Fisher calculator gives the baryonic mass of a spiral galaxy from its flat rotation speed with M = 47·v⁴, the stellar and gas masses for a given gas fraction, the dynamical mass inside a radius and the share of baryons in that mass.

How the calculation works

  • Enter the flat rotation speed in km/s.
  • Enter the gas fraction of the baryons and a radius in kpc.
  • Read the baryonic mass, the stellar mass and the dynamical mass.

Example

A galaxy rotating at 220 km/s has a baryonic mass of about 110.10 G☉, which is 1.84 times the Milky Way. With 10 % of gas, the stars weigh 99.09 G☉ and the gas 11.01 G☉. Inside 30 kpc the dynamical mass is 337.60 G☉, so baryons make 32.6 % of it. Doubling the speed would multiply the mass by 16.

Why it matters

The calculator helps astronomy students, amateur astronomers and teachers who work with rotation curves and galaxy scaling relations, want to estimate the mass of a spiral galaxy from an observed line width, or illustrate the dark matter evidence in a lesson.

Good to know

The relation applies to rotationally supported disk galaxies and uses the flat part of the rotation curve, not the peak. Masses are shown in billions of solar masses, so 100 means 10¹¹. The value of A has an uncertainty of about 10 %, and the result also depends on the distance if the speed is inferred from other data. The dynamical mass uses the circular orbit approximation, and the baryon share compares two masses from different measurements.

The Hubble law calculator gives distances from redshift, the Drake equation calculator estimates civilizations in the Galaxy, the orbital period calculator treats Kepler motion and the distance modulus calculator converts magnitudes into distance.

Frequently asked questions

What is the Tully-Fisher relation?

The Tully-Fisher relation, found by Brent Tully and Richard Fisher in 1977, links the rotation speed of a spiral galaxy to its luminosity: faster galaxies are brighter. In its baryonic form, by Stacy McGaugh and colleagues, the baryonic mass (stars plus gas) is proportional to the fourth power of the flat rotation speed, M = A × v⁴ with A close to 47 solar masses per (km/s)⁴.

How do I use it?

Enter the flat rotation speed measured from the 21 cm line width or a rotation curve. A galaxy with 220 km/s, similar to the Milky Way, has a baryonic mass of about 1.1 × 10¹¹ solar masses by this relation. A dwarf galaxy at 50 km/s has about 3 × 10⁸. Doubling the speed multiplies the mass by 16. Combined with a luminosity, it gives a distance.

How is the dynamical mass found?

For circular orbits, the mass inside a radius R is M = v² × R / G. With G = 4.301 × 10⁻⁶ kpc (km/s)² per solar mass, a speed of 220 km/s and a radius of 30 kpc give about 3.4 × 10¹¹ solar masses. Comparing it with the baryonic mass shows that most of the mass at large radius is not visible, which is evidence of dark matter.

How accurate is the relation?

The baryonic relation has a small scatter of about 0.1 dex across five orders of magnitude of mass, and it is a challenge for models of galaxy formation. The value of A depends on how stellar masses are estimated. Use the result as an estimate within a factor of about 1.5, and note that the Milky Way’s own baryonic mass is uncertain.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.