Skip to content
Omnikalc

Rainwater pH calculator: why clean rain is slightly acidic

Enter the CO2 level in the air and the water temperature to get the pH of pure water in equilibrium with the atmosphere, the dissolved CO2 and the change since pre-industrial times.

Updated on
Your inputs
ppm

Value out of range

°C

Value out of range

Value out of range

Results

pH of water in equilibrium with the air

5.60

Dissolved CO₂

0.63 mg/L

Hydrogen ion concentration
2.53 µmol/L
pH at the pre-industrial level of 280 ppm
5.69
Increase of H⁺ compared with 280 ppm
22.5%
pH if the CO₂ in the air doubled
5.45

Even the cleanest rain is slightly acidic. The reason is carbon dioxide, which dissolves in water and forms carbonic acid. This calculator gives the pH of pure water in equilibrium with the air, the dissolved CO₂ and how much the acidity has changed since the pre-industrial level of 280 ppm. It explains why a pH of about 5.6 is the natural reference for unpolluted rain, and why “acid rain” is defined as rain below that value.

How the calculation works

  • Henry’s law: dissolved CO₂ = K_H × partial pressure, with K_H = 0.034 mol/(L·atm) at 25 °C, corrected for temperature with an exponent of 2400 × (1/T − 1/298.15)
  • Partial pressure of CO₂ = concentration in ppm ÷ 1,000,000 atm at normal pressure
  • First dissociation: CO₂ + H₂O ⇌ H⁺ + HCO₃⁻, with K₁ = 10^(−pKa1)
  • Hydrogen ion concentration [H⁺] = √(K₁ × dissolved CO₂), because [H⁺] ≈ [HCO₃⁻]
  • pH = −log₁₀[H⁺]

Example

Water in balance with air at 420 ppm and 25 °C dissolves 0.63 mg/L of CO₂ and has a [H⁺] of 2.53 µmol/L, which gives a pH of 5.60. At the pre-industrial level of 280 ppm, the pH would be 5.69, so the hydrogen ion concentration has risen by 22.5 %. If the CO₂ in the air doubled, the pH would fall to 5.45.

Why it matters

The result sets the baseline for judging rain, fog and lakes without a buffer. Rain with a pH of 5.6 is natural; rain at 4.5 or lower shows additional acids such as sulfuric and nitric acid from combustion. The same chemistry, in a buffered solution, explains the acidification of the ocean, where more CO₂ lowers the carbonate available to shell-forming organisms.

Good to know

The formula assumes pure water with no other ions, so the real pH of rain depends on dust, ammonia and sea salt, which can raise it above 6. The calculation also ignores the second dissociation and the autoionisation of water, which only matter at very low CO₂. Colder water holds more CO₂, but pH changes only slightly. The ocean is not pure water: its high alkalinity keeps the pH near 8.1, so this tool does not apply to seawater.

In practice

Compare a measured rain sample with the value of about 5.6. A pH much lower points to pollution, and a pH higher points to alkaline dust. For a swimming pool or an aquarium, use a calculator with alkalinity. The tool is educational.

Frequently asked questions

Why is clean rain acidic?

Rain dissolves the CO₂ of the air and forms carbonic acid, a weak acid. At 420 ppm and 25 °C this gives a pH of about 5.60, even without any pollution.

What pH counts as acid rain?

Rain with a pH below about 5.6 is usually called acid rain, because that is the natural value from atmospheric CO₂. Strong acids from sulfur and nitrogen oxides can bring it down to 4 or lower.

Does more CO₂ change the pH of rain a lot?

Only slightly. Going from 280 to 420 ppm lowers the pH of pure water by about 0.1 units, which is a rise of 22.5 % in hydrogen ions. In a buffered system such as the ocean the effect is also small in pH but important for chemistry.

Can I use it for seawater?

No. Seawater contains bicarbonate and carbonate that buffer the pH near 8.1. This calculator describes pure water only.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.