Skip to content
Omnikalc

Hangboard calculator: how much weight to add for 70, 80 or 90 percent of your max hang

Enter your body weight, the weight you added in a max hang test and a target intensity to get your maximum load, your relative finger strength and the weight to add or remove for each session.

Updated on
Your inputs

Value out of range

Value out of range

%

Value out of range

Results

Max load as a share of body weight

130%

Weight to add (negative = take weight off with a pulley or feet)

17.7

Maximum total load: body weight + added weight
215.0
Total load at the target intensity
182.8
Weight to add at 70 % of max
-14.5
Weight to add at 80 % of max
7.0
Weight to add at 90 % of max
28.5

Finger strength training on a hangboard works best when the load is controlled. The usual method is to test the maximum load you can hold for about 7 to 10 seconds on a chosen edge, then train at a percentage of that maximum. This calculator turns your test into the weight to add or remove for any target intensity and gives your relative finger strength as a share of body weight.

How the calculation works

  • Maximum total load = body weight + added weight in the test
  • Relative strength = maximum total load ÷ body weight × 100
  • Training load = maximum total load × target intensity
  • Weight to add = training load − body weight (negative means taking weight off)

Added weight is positive when you hang with a belt or a weighted vest and negative when you need a pulley or your feet on a chair to reduce the load.

Example

You weigh 165 lb and hold 50 lb of added weight on a 20 mm edge in your test. The maximum total load is 215 lb, which is 130 % of your body weight. To train at 85 %, the total load is 182.8 lb, so you add 17.8 lb. At 70 % you need to take off 14.5 lb of weight with a pulley or by touching the ground, at 80 % you add 7 lb, and at 90 % you add 28.5 lb.

Why it matters

Training too light gives little stimulus, and too heavy increases the risk of finger pulley and tendon injuries. A fixed percentage lets you adjust the load each cycle after a new test and compare weeks of training. Relative strength is also useful to compare with climbing grades.

Good to know

The test depends on the edge size, the grip (half crimp, open hand), the duration and your warm-up. Compare only tests done the same way. The result is a guide: stop if you feel sharp pain in the fingers, and keep rest days between sessions. Beginners and teenagers should not use maximum loads. If you have finger pain or an injury, ask a physiotherapist.

In practice

Test once every 4 to 8 weeks, after a good warm-up and when rested. Train at 80 to 90 % for short hangs and lower intensities for repeaters. Record the date, the edge and the weight. This tool is for education and is not medical advice.

Frequently asked questions

What is a max hang test?

It is a test in which you hang on a fixed edge, usually 20 mm, with added weight until you can hold only about 7 to 10 seconds. The heaviest load you can hold is your maximum hang.

What percent of max should I train at?

Many climbers use about 80 to 90 % for short maximum hangs of 7 to 10 seconds and 60 to 75 % for repeaters. Choose the intensity from your program and adjust it with how you feel.

What if I cannot hold my body weight?

Enter a negative added weight, for example -20 lb, if you needed help from a pulley or from your feet to hold the test. The result will then show how much weight to take off.

How often should I test?

Every 4 to 8 weeks is common. More frequent tests are tiring for the fingers and do not show real progress.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.