Skip to content
Omnikalc

How do I set up a backyard zip line?

Enter the span between anchors, the cable height at each end, the sag with a rider, how far the rider hangs below the cable and the cable needed to wrap each anchor: get the slope, the cable to buy, the sag and the ground clearance at mid-span.

Updated on
Your inputs
ft

Value out of range

ft

Value out of range

ft

Value out of range

%

Value out of range

ft

Value out of range

ft

Value out of range

Results

Slope

5.0 %

A common slope range for backyard zip lines

Cable to buy

112 ft

Ground clearance at mid-span

2.5 ft

Use a rated cable, trolley and harness or seat, anchor only to sound trees or posts, and keep children supervised
Sag at mid-span with a rider
2.0 ft

A backyard zip line is a steel cable stretched between two solid anchors, with a trolley that rolls down it. The ride depends on three things: the slope, the sag when someone is hanging on the cable, and the clearance between the rider’s feet and the ground. This calculator works out all three and the length of cable to buy.

How the calculation works

  • Height drop = start height − end height
  • Slope = drop ÷ span × 100
  • Cable to buy = √(span² + drop²) + cable to wrap each anchor × 2
  • Sag at mid-span = span × sag share
  • Ground clearance = average cable height − sag − rider’s feet below the cable

For a 100 ft span from 12 ft down to 7 ft, the slope is 5.0% and you need about 112 ft of cable, allowing 6 ft at each anchor. With 2% sag, the cable dips 2.0 ft under a rider. A rider whose feet hang 5 ft below the cable clears the ground by 2.5 ft at mid-span.

Choosing the slope

Slope Ride
Under 2% Riders may stop before the end
2 to 4% Gentle, good for children
4 to 6% Lively, needs a reliable brake
Over 6% Fast arrival, for experienced builders only

Heavier riders go faster and make the cable sag more, so test with the heaviest rider and adjust the tension.

Clearance

The lowest point of the ride is usually past the middle, closer to the end where the cable is lowest. Leave enough height for the tallest rider’s feet plus a margin, and clear the path of branches, rocks, fences and anything else a rider could hit.

Anchors and hardware

  • Anchor only to large, healthy trees or properly set posts; use tree protection under the cable wrap.
  • Use cable, clamps, turnbuckles and a trolley rated for the load, with a generous safety factor.
  • A stop block or spring brake at the end, and a soft landing area, prevent hard arrivals.
  • Commercial backyard kits come with instructions for tension and sag; follow them.

Safety

Supervise children, set a weight limit, and inspect the cable, clamps and anchors before each season and after storms. Wear a helmet, and use a harness or seat designed for zip lines. Check with your homeowner’s insurance and any local rules before installing.

Frequently asked questions

What slope should a backyard zip line have?

Usually about 2 to 6%; 100 ft from 12 ft down to 7 ft is a 5.0% slope.

How much cable do I need for a 100 ft zip line?

About 112 ft: the sloped length plus 6 ft to wrap each anchor.

How much does a zip line sag with a rider?

Often about 2% of the span, 2 ft on a 100 ft line.

How high should the cable be at mid-span?

High enough that the rider's feet clear the ground with the sag: here 2.5 ft of clearance.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.