Skip to content
Omnikalc

How many boards do I need for my cuts?

Find how many pieces you can cut from each board with the saw kerf, how many boards to buy, the offcut left on each and the material cost.

Updated on
Your inputs
ft

Value out of range

in

Value out of range

in

Value out of range

Value out of range

$

Value out of range

Results

Pieces per board

4

Boards to buy

5

Offcut left on each full board
7.5 in
Waste on a full board
7.8%
Spare pieces you could cut
0
Lumber cost
$30

Buying lumber for a project usually means turning a list of pieces into a number of boards. Buy too few and you make a second trip; buy too many and you pay for offcuts. This calculator works out how many pieces each board yields, counting the saw kerf, then the boards to buy and the waste.

Why the saw kerf matters

Every cut turns a thin strip of wood into sawdust. A typical circular saw or table saw blade removes about 1/8 in, while thin-kerf blades remove 3/32 in and a hand saw a little less. On an 8 ft board cut into 22 in pieces, four cuts lose half an inch. That sounds small, but it can be the difference between getting 4 or 5 pieces when pieces are close to a fraction of the board.

The formula

The number of pieces per board is the board length plus one kerf, divided by the piece length plus one kerf, rounded down. For a 96 in board, 22 in pieces and a 1/8 in kerf: (96 + 0.125) ÷ (22 + 0.125) = 4.3, so 4 pieces. The offcut is 96 − 4 × 22.125 = 7.5 in, or 7.8% of the board.

The boards to buy are the pieces needed divided by the pieces per board, rounded up. Twenty pieces take 5 boards, about $30 at $6 a board.

Tips for less waste

  • Start each board with a squaring cut of 1/4 to 1/2 in if the factory ends are rough or out of square, and shorten the board length in the calculator to match.
  • Check boards for knots, splits and twist at the store. Plan to cut around defects, and buy one extra board for a large project.
  • Mix piece lengths: if you have short parts too, cut them from the offcuts of the long ones.
  • Remember that nominal sizes differ from actual sizes: a 2×4 is 1.5 × 3.5 in, though lengths are usually full.
  • For sheet goods such as plywood, the layout is two-dimensional, so plan the cuts on a sketch of the 4 × 8 ft sheet.

When pieces come out exact

If your pieces fit almost perfectly, double-check the kerf and leave a little room: boards are sometimes a fraction short, and ends can be damaged in handling.

Frequently asked questions

How many 22 in pieces from an 8 ft board?

4 pieces with a 1/8 in kerf, leaving a 7.5 in offcut.

How wide is a saw kerf?

About 1/8 in for standard blades and 3/32 in for thin-kerf blades.

How do I calculate pieces per board?

(Board length + kerf) ÷ (piece length + kerf), rounded down.

Should I buy extra lumber?

Buy one extra board for large projects to allow for defects and mistakes.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.