Hardwood floors can be sanded and refinished several times over their life, which brings worn, scratched or dull floors back to looking new. This calculator compares the cost of hiring a pro with renting a sander and doing the job yourself, and works out how much finish you need.
Pro prices
Floor refinishers usually charge per square foot:
- Screen and recoat, about $1 to $2 per sq ft: a light buff of the existing finish and a fresh topcoat, for floors that are dull but not worn through.
- Full sand and refinish, about $3 to $5 per sq ft: sanding down to bare wood and applying several coats of finish.
- Sand, stain and refinish, about $4 to $6 per sq ft: the same with a stain to change the color.
At $4 per sq ft, a 500 sq ft floor costs about $2,000. Stairs, repairs to damaged boards and moving furniture often cost extra.
Doing it yourself
A drum or orbital sander rents for about $50 to $100 a day, and a 500 sq ft floor usually takes a weekend to sand. Finish covers about 400 to 500 sq ft per gallon per coat; three coats on 500 sq ft at 500 sq ft per gallon need 3 gallons. At $50 a gallon, plus $140 for two days of rental and $60 of sandpaper and supplies, the job costs about $350, saving about $1,650.
Is it worth doing yourself?
The savings are real, but a drum sander is powerful: stop moving for a moment and it cuts a dip into the floor. Orbital sanders are slower but much more forgiving and a good choice for a first project. Practice in a closet or a spare room first, sand with the grain and go through the grits in order, often 36, 60 then 100.
Finish choices
- Water-based polyurethane: clear, low odor, dries in a few hours, so you can apply several coats in a day.
- Oil-based polyurethane: warmer amber tone, more forgiving to apply, but slow to dry and strong smelling.
- Hardwax oil: a natural look and easy spot repairs, with more frequent maintenance.
Wait at least a day before walking on the floor in socks and two weeks or more before putting rugs back, as finishes keep curing. Engineered floors with a thin wear layer can only be sanded lightly once or twice; check the thickness at a floor vent before you start.