Skip to content
Omnikalc

How much anti-slip coating do you need for a floor?

Enter the floor area, the coats, the coverage of one container per coat, the container price and the labor per square foot: get the containers, the product cost, the labor and the total.

Updated on
Your inputs
sq ft

Value out of range

Value out of range

sq ft

Value out of range

$

Value out of range

$

Value out of range

Results

Containers to buy

2

Total cost

$200

Clean and degrease the floor thoroughly, let it dry fully and test the product on a hidden spot; check that it suits your surface, such as glazed tile, stone or a tub, and reapply as the label says, as wear reduces grip over time
Product cost
$80
Labor cost
$120

Slippery floors in bathrooms, kitchens and entryways are a leading cause of falls at home, especially for older adults. An anti-slip treatment or coating adds grip to tile, stone, concrete or a tub without replacing the floor. This calculator works out how much product to buy and what the job costs with or without a pro.

How the calculation works

  • Containers to buy = floor area × coats ÷ coverage per container per coat, rounded up
  • Product cost = containers × price per container
  • Labor cost = floor area × labor per sq ft
  • Total cost = product + labor

Treating 60 sq ft of bathroom floor with 2 coats, at 100 sq ft per quart per coat, takes 2 quarts, or $80 of product at $40 a quart. With $2 per sq ft of labor, labor costs $120 and the total is $200. Doing it yourself, set labor to zero.

Types of anti-slip treatment

Type How it works Best for
Etching solution micro-roughens the surface, invisible glazed tile, stone, tubs
Clear grip coating resin with fine grit concrete, sealed floors, outdoor steps
Anti-slip paint paint with added grit garage, basement, decks
Adhesive treads and strips textured tape tubs, stairs, ramps
Rubber-backed mats loose mats quick, removable fix

Applying it

  1. Clean the floor with a degreaser and rinse well; soap film and wax stop the product from working.
  2. Let the floor dry completely, then test the product on a hidden spot to check the look.
  3. Apply evenly with the tool the label calls for, respecting the contact time for etching products.
  4. Rinse or let cure for the time stated before walking on it.

Keeping the grip

Wear and the wrong cleaners reduce grip over time. Use mild cleaners, avoid waxes and oily soaps, and reapply as the manufacturer recommends, often every few years for coatings in busy areas. A simple test is to wet the floor and check the grip with bare feet and shoes.

More fall prevention

Anti-slip treatment works best together with grab bars by the toilet and shower, good lighting, a non-slip mat inside the tub and removing loose rugs. For someone at high risk of falls, an occupational therapist can review the whole home.

Frequently asked questions

How much anti-slip coating do I need?

2 quarts for 60 sq ft in 2 coats at 100 sq ft per quart.

How much does an anti-slip floor treatment cost?

About $200 for 60 sq ft with $80 of product and $2 per sq ft of labor.

Does anti-slip treatment work on tile?

Yes, etching products add grip to glazed tile, stone and tubs.

How often should anti-slip coating be reapplied?

As the label says, often every few years in busy areas.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.