Skip to content
Omnikalc

How much landscape edging do I need?

Find the edging pieces and stakes for a garden bed, path or lawn border, with a margin for curves and overlaps, and the total cost.

Updated on
Your inputs
ft

Value out of range

%

Value out of range

ft

Value out of range

ft

Value out of range

$

Value out of range

$

Value out of range

Results

Edging pieces

8

Stakes

20

Length to buy
63.0 ft
Total cost
$140
Leave the top about ½ in above the soil so the mower wheel can ride along it
Cost per foot
$2.33

Edging gives garden beds, paths and lawn borders a crisp line and keeps grass from creeping into mulch. This calculator turns the length you want to edge into the number of edging pieces and stakes to buy, with a margin for curves, and the total cost.

Measuring the length

Walk the outline of each bed with a long tape measure, or lay a garden hose along the curve and measure the hose. For straight runs, add up the sides. Do not edge the side of a bed that meets a wall or a fence. Add the lengths of every bed together.

Margin for curves and overlaps

Most edging systems overlap or connect at the joints, and curves use a little more material than a straight measurement suggests. A 5% margin covers gentle curves and joints, while tight, wavy beds may need 10%. With 60 ft of beds and 5% extra, you buy 63 ft of edging.

Pieces and stakes

Divide the length to buy by the length of one piece and round up. Steel and aluminum edging often comes in 8 ft or 10 ft strips, plastic edging in rolls of 20 to 60 ft, and pavers or stone edging by the unit. In the example, 63 ft takes 8 strips of 8 ft.

Stakes hold the edging in place. Manufacturers usually recommend one every 2 to 4 ft, closer on curves and in loose soil. At one every 3 ft, 60 ft needs 20 stakes. Edging pieces sometimes include a stake or two, so check the package before buying extra.

Cost

At $15 per strip and $1 per stake, the example costs about $140, or $2.33 per foot. Plastic rolls are cheaper, while steel lasts decades and gives the cleanest line. Brick or stone edging costs more but doubles as a mowing strip.

Installation tips

  • Cut a clean trench with a flat spade, about 4 in deep, before setting the edging.
  • Leave the top about ½ in above the soil, so the mower wheel can roll along it without hitting the blade.
  • Overlap or connect joints firmly so the line stays continuous.
  • Backfill and tamp the soil on both sides, then water to settle it.
  • Call 811 before digging deep trenches near utility lines.

Frequently asked questions

How much edging do I need?

The bed length plus about 5% for curves: 63 ft for 60 ft of beds.

How many stakes for landscape edging?

About one every 2 to 4 ft: 20 stakes for 60 ft at 3 ft spacing.

How deep should landscape edging go?

About 4 in into the soil, with the top about ½ in above ground.

How much does landscape edging cost?

About $140 for 60 ft of steel strips at $15 each plus stakes, or $2.33 per foot.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.