Skip to content
Omnikalc

What size transformer do I need for landscape lighting?

Add up the wattage of your low-voltage garden lights, pick a transformer with headroom, and check the voltage left at the end of the cable run.

Updated on
Your inputs

Value out of range

W

Value out of range

%

Value out of range

ft

Value out of range

Results

Total load

40 W

Transformer size to choose

60 W

Current at 12 V
3.3 A
Voltage drop (all lights at the end)
1.06 V
Voltage at the last fixture
10.9 V
Good: most LED fixtures work well above about 10.5 V

Low-voltage landscape lighting runs at 12 volts from a transformer plugged into an outdoor outlet. It is safe to install yourself, but two numbers decide whether it works well: the transformer size and the voltage drop along the cable. This calculator checks both.

Total load

Add up the wattage of every fixture. LED path lights typically use 2 to 5 W, spotlights 4 to 10 W and well lights up to 15 W. Ten 4 W path lights draw 40 W. At 12 V, the current is 40 ÷ 12 = 3.3 A.

Transformer size

A transformer should not run at its full rating. Leave 20 to 25% headroom so it runs cool and you can add lights later. With 25% headroom, 40 W calls for at least 50 W, so the next standard size, 60 W, is enough. Common sizes are 60, 100, 150, 200, 300 and 600 W.

Voltage drop

Every foot of cable has resistance, and the current through it loses voltage on the way out and back. The worst case is when all the lights sit at the far end:

drop = 2 × length × current × resistance per foot

12-gauge cable has about 1.59 ohms per 1,000 ft. On a 100 ft run carrying 3.3 A, the drop is about 1.1 V, leaving 10.9 V at the last light. Most LED fixtures work well from about 9 to 15 V, but older halogen lamps dim noticeably below about 10.5 V. Lights spread along the cable see less drop than this worst case.

Reducing voltage drop

  • Use thicker cable: 10 gauge has about 40% less resistance than 12 gauge.
  • Split the lights into two or more runs from the transformer instead of one long chain.
  • Feed the cable to the middle of a group of lights, in a T or a loop, rather than to one end.
  • Use a multi-tap transformer with 13, 14 or 15 V outputs for long runs.
  • Switch remaining halogen fixtures to LED, which draws a fraction of the current.

Installation tips

  • Plug the transformer into a GFCI-protected outdoor outlet with an in-use cover.
  • Bury cable 6 in deep or run it under mulch where it will not be cut by edging tools.
  • Use waterproof connectors rated for direct burial.
  • Set a photocell or timer to switch lights at dusk.

Frequently asked questions

What size transformer do I need for landscape lights?

Total watts plus 20 to 25%: 60 W for ten 4 W lights.

How do I calculate voltage drop for 12 V lighting?

2 × length × amps × ohms per foot: about 1.1 V for 100 ft of 12 AWG at 3.3 A.

What voltage do LED landscape lights need?

Most work well from about 9 to 15 V.

How deep should landscape lighting cable be buried?

About 6 in, or under mulch away from edging tools.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.