Skip to content
Omnikalc

Riprap calculator: how many tons of stone do you need?

Enter the length, width and thickness of the area to protect to get the tons of riprap to order, the volume, the truckloads and the cost.

Updated on
Your inputs
ft

Value out of range

ft

Value out of range

in

Value out of range

tons per yd³

Value out of range

%

Value out of range

$

Value out of range

tons

Value out of range

Results

Riprap to order

110 tons

Volume in place
66.7 yd³
Truckloads
8
Material cost
$6,050

Riprap is the layer of rough stone that stops running water from eating away a bank, a slope or a culvert outlet. Ordering it is a matter of area, thickness and weight. This calculator gives the tons to order, the volume in place, the number of truckloads and the cost for an area you want to protect.

How the calculation works

  • Volume = length × width × thickness (in feet), converted to cubic yards by dividing by 27
  • Tons = volume × weight in place per cubic yard × (1 + waste allowance)
  • Truckloads = tons ÷ truck capacity, rounded up
  • Cost = tons × price per ton

Riprap in place weighs about 1.4 to 1.6 tons per cubic yard, less than solid rock, because of the gaps between the stones.

Example

A bank 100 ft long and 12 ft wide (measured along the slope) with an 18 in. layer: volume in place is 100 × 12 × 1.5 ÷ 27 = 66.7 yd³. At 1.5 tons per yard and a 10 % allowance, you need 110 tons, delivered in 8 truckloads of 14 tons. At $55 a ton, the material costs $6,050.

Why it matters

Erosion costs far more than the stone to prevent it. A bank that is undercut loses soil, trees and sometimes a building, and the repair is much costlier than an engineered layer of the right size. Ordering an accurate quantity avoids running short in the middle of a job, when trucks are already booked, and avoids leftover stone you must haul away.

Good to know

The size of the stone matters more than the tonnage: it depends on the speed of the water and the slope, and is set by an engineer or the local permitting authority. Use geotextile fabric below the stone. Slopes steeper than 2 horizontal to 1 vertical are hard to stabilize. In many places, working along a stream needs a permit. This tool is for estimating quantities only.

The gravel calculator estimates crushed stone by the yard, the retaining wall calculator sizes a block wall, and the stone wall calculator estimates a dry-laid wall.

Frequently asked questions

What is riprap?

Riprap is a layer of large, angular stones placed on a shoreline, stream bank, culvert outlet or slope to absorb the energy of water and prevent erosion. The stones are heavy enough that moving water cannot shift them.

How thick should the layer be?

A common rule is at least 1.5 times the diameter of the largest stones, and not less than 12 inches. Larger stones and thicker layers are used where the current is faster. A filter fabric or gravel layer underneath keeps the soil from washing out.

How much does riprap weigh?

Placed riprap weighs about 1.3 to 1.6 tons per cubic yard, depending on the stone and how tightly it is packed. Solid rock is about 2.6 tons per cubic yard, and the voids between the stones take up the rest.

How do I convert the tonnage into an order?

Multiply the volume in place by the weight per yard, then add an allowance for waste and settling. Suppliers sell by the ton and trucks carry 14 to 20 tons, so round up the loads.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.