Skip to content
Omnikalc

How much stone do I need for a stone wall?

Estimate the volume of a dry-stacked or mortared stone wall, the tons of stone with the gaps between stones and a margin for culls, and the cost.

Updated on
Your inputs
ft

Value out of range

ft

Value out of range

ft

Value out of range

%

Value out of range

lb/cu ft

Value out of range

%

Value out of range

$

Value out of range

Results

Stone to order

7.6 tons

Stone cost

$1,906

Wall volume
120 cu ft
Wall face area
60.0 sq ft
Stone per unit of face area
254 lb per sq ft
Taper the faces inward by about 1 in per foot of height for stability

A dry stone wall is built without mortar, held together by gravity, careful placement and the friction between stones. Whether you build one dry or with mortar, the first question is how much stone to order. This calculator estimates the wall volume, the tons of stone and the cost.

Wall volume

Multiply the length, the height and the average thickness. A garden wall 20 ft long, 3 ft high and 2 ft thick has a volume of 120 cu ft. Dry walls are usually wider at the base than at the top, so use the average of the two thicknesses. Include the part below ground if you set the first course in a trench.

Voids and density

Stones never fit perfectly, so a wall contains gaps, even when they are packed with small hearting stones. Dry walls of rough fieldstone often have 25 to 35% voids; cut, squared stone has less. Solid stone weighs about 160 to 170 lb per cubic foot for granite, limestone and sandstone, less for some light sandstones.

With 30% voids and 165 lb per cubic foot, the 120 cu ft wall holds 120 × 0.7 × 165 = 13,860 lb of stone, about 6.9 tons.

Extra for culls

Not every stone in a delivery is usable: some are too round, too small or break when shaped. Adding 10% brings the order to about 7.6 tons. At $250 a ton for fieldstone, that is about $1,906 before delivery. Prices vary widely, from under $100 a ton for local fieldstone to several hundred for quarried wall stone.

The calculator also shows the weight of stone per square foot of wall face, about 254 lb here, a handy figure when comparing quotes given per face area.

Building tips

  • Batter: taper both faces inward, about 1 in for every foot of height, so the wall leans into itself.
  • Base: make the base at least half as wide as the wall is tall, and set the largest stones in the first course on compacted gravel.
  • Through stones: place long stones across the full width every 3 to 4 ft along each course to tie both faces together.
  • One over two: cross every joint, like brickwork, so no vertical seam runs through two courses.
  • Hearting: fill the core with small stones as you go, never with soil.
  • Coping: finish with heavy flat stones or stones set on edge to protect the top.

Walls taller than about 3 to 4 ft, or retaining walls holding back soil, may need engineering and a permit.

Frequently asked questions

How many tons of stone for a stone wall?

About 7.6 tons for a 20 × 3 × 2 ft wall with 30% voids and 10% extra.

How much does a cubic foot of stone weigh?

About 160 to 170 lb for solid granite, limestone or sandstone.

How thick should a dry stone wall be?

At the base, at least half the wall's height.

What is batter on a stone wall?

The inward slope of the faces, about 1 in per foot of height.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.