A shed dormer raises part of a sloped roof to create a wall of standing headroom and room for windows in an attic. Its size is set by the main roof pitch, the shallower pitch of the dormer roof and the height of its front wall. This calculator works out how deep the dormer runs, the floor and volume it adds, and the wall and roof areas you will need to frame, sheathe and finish.
How the calculation works
- Rise = dormer face height − knee wall height at the face
- Dormer depth = rise ÷ (tan(main roof pitch) − tan(dormer roof pitch))
- Floor area under the dormer = dormer width × depth
- Volume added = width × rise × depth ÷ 2
- Face wall = width × rise; both cheek walls = rise × depth
- Dormer roof area = width × depth ÷ cos(dormer roof pitch)
On a 45° roof, a dormer face 7.5 ft high standing where the old roof was 4 ft above the floor rises 3.5 ft. With a 14° dormer roof, about 3:12, it runs 4.7 ft back before meeting the main roof. A 12 ft wide dormer then covers 55.9 sq ft of floor and adds about 98 cu ft of space. You will frame about 42 sq ft of face wall before windows, 16.3 sq ft of cheek walls for both sides and 57.7 sq ft of dormer roof.
Pitch and depth
The flatter the dormer roof compared with the main roof, the deeper the dormer reaches into the attic. On a steep 45° roof, a shed dormer is compact; on a 30° roof, the same rise reaches much farther back, which gives more headroom but more roof to frame. If the dormer roof is as steep as the main roof, it never meets it, so the calculator warns you.
| Dormer roof | Pitch | Usual roofing |
|---|---|---|
| 2:12 | 9.5° | membrane or low-slope metal |
| 3:12 | 14° | shingles with low-slope underlayment |
| 4:12 | 18.4° | standard shingles |
Planning tips
- A dormer cuts rafters, so the opening needs doubled rafters and headers; have an engineer or the roof truss maker check the design.
- Most towns require a building permit, and some neighborhoods limit dormers on the street side.
- The IRC asks for a 7 ft ceiling over at least half of a habitable attic room, and bedrooms need an egress window.
- Flash the cheek walls and the tie-in with the main roof carefully: that is where dormers leak.
- Insulate the cheek walls and the dormer roof to the same level as the rest of the house.