Skip to content
Omnikalc

Yeast pitch rate calculator: how much yeast should you pitch?

Enter the batch volume, the original gravity, the pitching rate and the viability to get the number of cells needed and the number of yeast packs.

Updated on
Your inputs

Value out of range

Value out of range

%

Value out of range

billion

Value out of range

Results

Cells needed

192 billion

Wort strength
13.5 °P
Viable cells in one pack
90 billion
Packs needed (rounded up)
3

Healthy fermentation starts with enough yeast. The yeast pitch rate calculator takes the batch volume, the original gravity, a pitching rate, the viability of the yeast and the cells in one pack and gives the wort strength in degrees Plato, the cells needed, the viable cells in one pack and the number of packs to pitch.

How the calculation works

  • Wort strength in degrees Plato ≈ 259 − 259 ÷ specific gravity. A gravity of 1.055 is about 13.5 °P.
  • Cells needed = pitching rate × volume in millilitres × degrees Plato. The pitching rate is expressed in millions of cells per millilitre per degree Plato, and the result is divided by 1 000 to give billions of cells.
  • Viable cells in one pack = cells in the pack × viability. A pack older than a few weeks holds fewer live cells than it says on the label.
  • Packs needed = cells needed ÷ viable cells per pack, rounded up to a whole pack.

Example

A 5 gal batch (18 927 mL) of 1.055 ale wort is 13.5 °P. At 0.75 million cells per mL per °P it needs 0.75 × 18 927 × 13.5 ÷ 1 000 = 192 billion cells. A pack of 100 billion cells at 90 percent viability holds 90 billion live cells, so the batch needs 2.13 packs, which means 3 packs or a starter.

Why it matters

Underpitching is one of the commonest causes of poor homebrew. A small, quick calculation tells you whether one pack is enough, how old yeast changes the answer, and when you need to make a starter or pitch two packs for a strong beer or a lager.

Good to know

The degrees Plato come from an approximation that is accurate to about 0.1 °P in the range of ordinary beers. The pitching rates are guides and are not the same for every yeast strain or every brewer. A starter or a pack count is a plan, and the best check is a fermentation that starts within 12 to 24 hours and finishes cleanly.

The homebrew ABV calculator estimates the strength of the finished beer and the yeast converter changes between fresh, dry and instant yeast amounts for baking.

Frequently asked questions

Why does the pitch rate matter?

Too few cells make the yeast work hard, stress it and produce off-flavors such as excess esters and sulfur, and a slow or stuck fermentation. Too many cells give a thin, yeasty beer with little yeast character. The standard rates aim for a clean, steady fermentation.

What rate should I use?

A common guide is 0.75 million cells per millilitre per degree Plato for ales, 1.0 for strong ales and 1.5 for lagers, since cold lager fermentation needs more cells. Some brewers raise the rate for very strong beers. Use the figure that your yeast supplier recommends if it differs.

What is a yeast starter?

A starter is a small batch of wort in which you grow the yeast before pitching, to raise the cell count. If the calculator says you need more than one pack, a starter of about 1 to 2 litres can multiply the cells by a factor of two to four, depending on how it is made and aerated.

How do I find the viability?

Fresh liquid yeast is near 95 percent viable at the packing date and loses about 20 percent a month in the fridge. Dry yeast stays much more viable for much longer. Many yeast makers and calculators publish a curve, and a haemocytometer count with a stain gives a measured figure.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.