Skip to content
Omnikalc

Soil available water calculator: how much water can my soil store for plants?

Enter the field capacity and wilting point of the soil, the root depth, the allowed depletion and the crop water use to get the available water and the days between irrigations.

Updated on
Your inputs
% by volume

Value out of range

% by volume

Value out of range

Value out of range

%

Value out of range

Value out of range

Results

Days between irrigations

9.0 days

Water holding capacity of the soil
1.80 in/ft
Total available water in the root zone
3.60 in
Readily available water
1.80 in

A soil is a tank, and the size of the tank decides how often plants need water. The soil available water calculator takes the field capacity, the wilting point, the root depth, the allowed depletion and the crop water use and gives the water holding capacity, the total and readily available water in the root zone and the days between irrigations.

How the calculation works

  • Water holding capacity = field capacity − wilting point, as a share of the soil volume. Field capacity is the water a soil holds after drainage, and the wilting point is the level below which plants cannot extract water.
  • Total available water = water holding capacity × root depth. A soil that holds 15% of its volume as available water holds 0.15 inch of water for each inch of depth.
  • Readily available water = total available water × allowed depletion. Watering when this share is used up keeps the plants from stress.
  • Days between irrigations = readily available water ÷ the crop’s daily water use.

Example

A loam with a field capacity of 30% and a wilting point of 15% holds 15% of its volume as available water, or 1.8 inches per foot. For roots 24 inches deep, the total available water is 0.15 × 24 = 3.6 inches. With 50% allowed depletion, 1.8 inches are readily available. At a crop use of 0.2 inches per day, the soil lasts about 9 days between irrigations.

Why it matters

Knowing how much water the soil stores lets you water deeply and less often, which saves water and builds stronger plants. It is used by gardeners, turf managers and farmers to set irrigation schedules, and to judge how much a rain or a watering will last.

Good to know

The calculation is a simplified water balance. It assumes the whole root zone starts at field capacity, that roots draw evenly from the full depth and that the crop use is steady. Rain, rising groundwater, compacted layers and salinity change the result. Use local soil data when you can.

The drip irrigation calculator sizes a system of emitters and the sprinkler run time calculator turns a depth of water into minutes of watering.

Frequently asked questions

What are field capacity and wilting point?

Field capacity is the amount of water a soil holds against gravity a day or two after it has been soaked and allowed to drain. The permanent wilting point is the moisture at which plants can no longer take up water and do not recover overnight. The gap between the two is the water plants can use.

How much water do different soils hold?

Sand holds about 0.5 to 1 inch of available water per foot, loam about 1.5 to 2 and clay loam or silt loam about 2 to 2.5. Organic matter increases the capacity. A soil test, or local soil survey data, gives better figures than typical values.

What is allowed depletion?

It is the share of the available water that plants may use before irrigation. For most crops 50% is a common value, so the plants never meet water stress. Shallow-rooted or sensitive crops, such as potatoes and many vegetables, use a lower value such as 30 to 40%.

Why do shallow roots need frequent watering?

A small root zone stores less water. With roots 6 inches deep, the same soil holds a quarter of the water it holds for 24-inch roots, so it must be watered about four times as often. Deep, less frequent watering encourages deeper roots.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.