Skip to content
Omnikalc

Broadcast spreader calibration calculator

Enter the weight of product caught during a timed test, your ground speed and swath width to get the application rate, the error against the target and the flow the spreader should deliver.

Updated on
Your inputs
lb

Value out of range

s

Value out of range

mph

Value out of range

ft

Value out of range

lb/ac

Value out of range

ac

Value out of range

Results

Application rate delivered

49.5 lb/ac

Error against the target

-17.5 %

Flow needed for the target

18.18 lb/min

Flow of the spreader
15.00 lb/min
Total product for the area
600 lb
Coverage rate
18.18 ac/h
Time to spread the area
0.55 h

The broadcast spreader calibration calculator gives the application rate that a spreader really delivers from a timed catch test, the error against your target, the flow to set to reach the target, the total product and the time needed for the area.

How the calculation works

  • Weigh the product caught during a timed test and enter the test duration in seconds.
  • Enter your ground speed and the effective swath width of the spreader.
  • Enter the target rate and the area, then read the rate, the error and the flow to set.

Example

A spreader that drops 7.5 lb in 30 s has a flow of 15.00 lb/min. At 5 mph on a swath of 30 ft, it applies 49.5 lb/ac, which is -17.5 % away from the target of 60 lb/ac. To reach the target, the flow must be adjusted to 18.18 lb/min. The area then takes 0.55 h to spread, and needs 600 lb of product.

Why it matters

The calculator helps farmers, gardeners, turf managers and landscapers who spread fertilizer, lime, seed or de-icing salt with a broadcast spreader and want an accurate dose. Too little product wastes the pass, and too much costs money and can burn plants or pollute the water.

Good to know

Run the test with the product that you will actually spread, because the flow depends on its density, moisture and particle size. Repeat the test two or three times and average the weights. Use the effective swath found with a pattern test, and keep the speed steady during the work, since the dose is inversely proportional to the speed. Adjust the gate opening, then test again until the error is within a few percent. This tool assumes a constant flow and ignores the overlap pattern, the wind and the slope. For liquids, use a sprayer calibration instead.

The sprayer calibration calculator does the same job for liquids, the seeding rate calculator sets the quantity of seed, the lawn fertilizer calculator gives the dose of nutrients and the manure application calculator handles organic spreading.

Frequently asked questions

How do I do a catch test?

Fill the hopper, lock the gate at the setting you want to test, and let the spreader run for a measured time, for instance 30 seconds, while it is stationary or driven over a tarp or a catch bag. Weigh what was delivered. The calculator scales the weight to a flow per minute, then combines it with the speed and the swath to give the rate per area.

How is the swath width defined?

The swath is the distance between two passes that gives an even coverage, not the farthest distance the product is thrown. For a centrifugal spreader it is usually half to two thirds of the maximum throw, and it is best found with a pattern test using trays. Using the maximum throw instead gives an application rate that is too low in the field.

Why does the real rate differ from the setting?

The settings on a spreader are a starting point. The flow depends on the density of the product, its moisture, the particle size and the wear of the gate. Two bags of the same fertilizer can flow differently. A catch test with your product on the day of the work is the only way to know the real flow.

What are the constants 495 and 600?

They come from the unit conversions. At one mile per hour a one foot swath covers 1/495 acre per minute. At one kilometer per hour a one meter swath covers 1/600 hectare per minute. The application rate is the flow per minute divided by the area covered per minute.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.