Skip to content
Omnikalc

Tobler hiking function calculator

Enter the slope, the distance and the type of ground to get the walking speed from Tobler’s function, the time to walk the leg and back, and the speed on the flat and on the best downhill grade.

Updated on
Your inputs
%

Value out of range

mi

Value out of range

Results

Walking speed on this slope

2.21 mph

Time to walk the leg

2.27 h

Time of the round trip

3.86 h

Walking speed on the way back
3.13 mph
Time of the return leg
1.60 h
Walking speed on the flat
3.13 mph
Fastest speed (gentle downhill, about -5 %)
3.73 mph

The Tobler hiking function calculator gives the walking speed of a hiker on a given slope with Waldo Tobler’s exponential function, the time of a leg, the return time on the opposite slope, and the fastest and flat-ground speeds, for a trail or for off-path ground.

How the calculation works

  • Enter the slope in percent, with uphill positive, and the distance of the leg.
  • Choose the ground: a path or an off-path factor.
  • Read the speed, the time of the leg and of the return.

Example

On a slope of 10 %, Tobler’s function gives a speed of 2.21 mph, so 5 mi take 2.27 h. On the way back, the slope is reversed and the speed is 3.13 mph, which takes 1.60 h, so the round trip lasts 3.86 h. On the flat the speed is 3.13 mph, and the best speed on a gentle downhill is 3.73 mph.

Why it matters

The calculator helps hikers, map makers, trip planners and students of geography who want a smooth model of the speed on a slope, compare the time up and down, and estimate the duration of a segment before adding rests and delays.

Good to know

The function was fitted on the data of Eduard Imhof for a walker on a trail with no load, so a pack, a group, bad weather or fatigue lower the speed. Apply it segment by segment on a route and not to the average slope of a whole day, because ups and downs do not cancel. The off-path factors are a rough guide. For long outings, add the stops, and compare the result with a Naismith estimate.

The hiking time calculator uses Naismith’s rule, the Pandolf calculator estimates the energy cost with a pack, the hiking water calculator plans the water and the VAM calculator measures climbing speed.

Frequently asked questions

What is Tobler’s hiking function?

Waldo Tobler, a geographer, proposed in 1993 an exponential function for the walking speed of a hiker on a slope: W = 6 × e^(−3.5 × |S + 0.05|) km/h, where S is the slope as a ratio. It is used in geographic information systems to compute travel times and cost surfaces on a map.

Why is the fastest speed on a slight downhill?

The function peaks when S = −0.05, that is a downhill of 5 percent, where the speed is 6 km/h. Walking on a gentle descent is easier than on the flat, because gravity helps. On steep descents, the speed falls again because the walker must brake. Going uphill, the speed falls quickly.

How is it different from Naismith’s rule?

Naismith’s rule adds a fixed time for each height gained to a base speed on the flat. Tobler’s function is continuous and depends on the slope of each segment, including descents that slow the walker, and it gives a speed on each slope instead of a total time.

How do I use it on a real route?

Split the route into segments of roughly constant slope, apply the function to each one and add up the times. For off-path walking, Tobler suggested multiplying the speed by 0.6, and rough ground can be slower. Add the time of rests and take a safety margin for a pack, a group and the weather.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.