Skip to content
Omnikalc

How much lumber for a garden footbridge?

Enter the span, the bridge width, the bearing on each bank, the deck board width and gap, and the stringer spacing: get the stringers and their length, the deck boards, the railing and the deck area.

Updated on
Your inputs
ft

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

Results

Stringers

3

Deck boards, cut to the bridge width

17

Stringer length
10.0 ft
Railing, both sides
16.0 ft
Deck area
24 sq ft
For spans up to about 8 ft, 2 × 8 treated stringers are typical; rest them on concrete pads or gravel above flood level, use ground-contact lumber and add a railing if the drop is more than a foot or two

A small wooden footbridge over a stream, a ditch or a pond is a classic garden project. Most are simple: two or three stringers spanning from bank to bank, deck boards across them and a railing. This calculator works out the stringers and their length, the deck boards, the railing and the deck area.

How the calculation works

  • Stringers = bridge width ÷ stringer spacing, rounded up, + 1
  • Stringer length = span + 2 × bearing on each bank
  • Deck boards = span ÷ (board width + gap), rounded up, each cut to the bridge width
  • Railing = span × 2, one on each side
  • Deck area = span × width

An 8 ft bridge 3 ft wide, with stringers every 2 ft and 12 in of bearing on each bank, needs 3 stringers 10 ft long. Deck boards 5.5 in wide with 1/4 in gaps take 17 boards, plus 16 ft of railing, for 24 sq ft of deck.

Typical stringer sizes

Span Treated stringers, 3 ft wide bridge
Up to 6 ft 2 × 6 or 2 × 8
6 to 8 ft 2 × 8
8 to 10 ft 2 × 10
10 to 12 ft 2 × 12, or doubled 2 × 10
Over 12 ft engineered beams; have it designed

These are rough guides for foot traffic only. A bridge that will carry a garden tractor, or a crowd, needs larger members.

Building tips

  • Use ground-contact rated treated lumber, or a naturally durable wood such as cedar or oak.
  • Rest the stringers on concrete pads, blocks or compacted gravel, never on bare soil, and above the usual high-water level.
  • For an arched look, cut the curve from wide boards or laminate thin strips, but keep enough depth in the middle.
  • Leave 1/4 in gaps between deck boards so water drains and leaves don’t pile up.
  • Use stainless or coated screws, and add grip strips if the deck will be in shade, where algae make wood slippery.
  • Add a railing if the drop is more than a foot or two, or if children use the bridge.

Check with your town before building over a stream or wetland: work in or near water often needs a permit.

Frequently asked questions

How many stringers for a 3 ft garden bridge?

Three, with stringers every 2 ft.

How long should bridge stringers be?

The span plus about 12 in of bearing on each bank, so 10 ft for an 8 ft span.

How many deck boards for an 8 ft bridge?

17 boards of 5.5 in with 1/4 in gaps.

What size stringers for an 8 ft footbridge?

Treated 2 × 8s are typical for foot traffic up to about 8 ft; use 2 × 10s up to about 10 ft.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.