Skip to content
Omnikalc

What length of garden hose should I buy?

Enter the distance from the spigot to the farthest spot you water: get the hose length with slack for corners, the standard size to buy, the watering time and the water held in the hose.

Updated on
Your inputs
ft

Value out of range

%

Value out of range

gal/min

Value out of range

gal

Value out of range

Results

Standard length to buy

75 ft

Buy the next standard size up rather than stretching a hose taut

Watering time

10.0 min

Hose length needed
72 ft
Water held in the hose
1.2 gal

A hose that is too short means dragging a sprinkler around or adding a second length; one that is much too long is heavy, kinks easily and loses pressure. This calculator sizes the hose from the distance to the farthest spot you water, then rounds up to a length you can actually buy. It also gives the watering time and how much water sits in the hose.

How the calculation works

  • Length needed = straight distance × (1 + slack)
  • Standard length = the next common size up: 25, 50, 75 or 100 ft
  • Watering time = water to apply ÷ flow at the spigot
  • Water held in the hose = π × (inside diameter ÷ 2)² × length

If the farthest corner of the garden is 60 ft from the spigot, adding 20% for going around beds and corners gives 72 ft, so buy a 75 ft hose. At 5 gal/min, putting down 50 gallons takes 10 minutes. A 75 ft hose of 5/8 in diameter holds about 1.2 gallons.

Measuring the distance

Walk the route the hose will take rather than measuring a straight line on a plan. Paths, beds, the corner of the house and the reel position all add length. If you are unsure, the 20% slack covers most gardens; for a winding route, use 30 to 50%.

Choosing the diameter

Diameter Use
1/2 in Light, short runs, balconies and small yards
5/8 in The usual garden size, a good balance of flow and weight
3/4 in Long runs, big sprinklers, highest flow but heavy

A wider hose loses less pressure over a long run but holds more water, so it is heavier to drag when full.

Measuring your flow

Time how long it takes to fill a 5-gallon bucket with the tap fully open. If it fills in one minute, the flow is about 5 gal/min. The flow at the end of a long hose is lower than at the spigot, and a sprinkler or spray nozzle reduces it further, so the time shown is a minimum.

Tips

  • Two shorter hoses joined with a connector are easier to store than one very long hose, and you can use just one for nearby jobs.
  • Drain the hose before freezing weather and store it out of the sun to make it last longer.
  • Water early in the morning to reduce evaporation, and water deeply rather than often.

Frequently asked questions

What length of hose do I need for 60 ft?

About 72 ft with 20% slack, so a 75 ft hose.

What hose diameter is best for a garden?

5/8 in is the usual balance of flow and weight.

How do I measure my water flow?

Time how long a 5-gallon bucket takes to fill; one minute means 5 gal/min.

Does a long hose reduce water pressure?

Yes, pressure drops with length, especially above 100 ft or with a narrow hose.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.