Skip to content
Omnikalc

Composite light-curing radiant exposure calculator

Enter the irradiance of the curing light at the tip, the loss at the distance of the restoration, the curing time and the radiant exposure needed by the material to get the exposure delivered, the share of the requirement and the minimum time.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs
mW/cm²

Value out of range

%

Value out of range

s

Value out of range

J/cm²

Value out of range

Results

Radiant exposure delivered

17.0 J/cm²

Share of the requirement
106 %
The requirement is met: the increment should be cured, if the light is well aimed
Irradiance at the restoration
850 mW/cm²
Minimum curing time
19 s

The composite light-curing calculator gives the radiant exposure delivered in J/cm², the share of the requirement met and the minimum curing time from the irradiance of the light, the loss at the restoration and the time.

How the calculation works

  • Enter the irradiance and the loss at the restoration.
  • Enter the curing time and the exposure needed.
  • Read the exposure and the share of the requirement.

Example

A light of 1000 mW/cm² loses 15 % at the restoration, so the irradiance there is 850 mW/cm². In 20 seconds this delivers 850 × 20 / 1000 = 17.0 J/cm², which is 106 % of the 16 J/cm² needed. The minimum time at this irradiance is 19 seconds.

Why it matters

The calculator helps dental students, dentists and dental assistants who set curing times, and teachers who show why the light output and the distance matter for the quality of a filling.

Good to know

The irradiance of the light at the tip is measured with a radiometer, and many cheap models are inaccurate by 10 to 20 %, so the value must be checked regularly. The tip must be clean, free of residual composite and held as close and as perpendicular to the surface as possible, since a tilt of the beam lowers the exposure delivered. Deeper layers receive less light, and the sum of the exposure depends on the shade, the translucency and the thickness of the increment, so a 2 mm increment is the usual limit, apart from bulk-fill materials. Most lights have a spectrum that fits the camphorquinone, and some composites with other photoinitiators require a wide-spectrum light. An under-cured composite is softer, wears faster, releases more monomer and has a higher risk of failing, while excess heat in the pulp is a risk for exposures of very high irradiance applied for a long time on a deep cavity. Eye protection is needed for blue light. The calculator is for education and the manufacturer instructions prevail.

The working length calculator treats root canals, the bleaching calculator treats peroxide gels, the DMFT calculator treats decay that leads to fillings and the crown-root ratio calculator treats the support of a restored tooth.

Frequently asked questions

What is radiant exposure?

It is the energy received per unit of area, the irradiance multiplied by the time. With the irradiance in mW/cm² and the time in seconds, dividing by 1000 gives J/cm². A light of 1000 mW/cm² for 20 seconds delivers 20 J/cm².

How much exposure is needed?

Studies suggest about 16 to 24 J/cm² to cure a 2 mm increment of a modern composite, with the exact value depending on the shade, the translucency and the filler. The leaflet of the material gives the recommended time at a given irradiance.

Why does distance matter?

The light spreads out and loses power with distance, and a deep box of a molar can be 6 to 10 mm from the tip. At that distance the irradiance can be reduced by a third or more, so the time must be longer.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.