Skip to content
Omnikalc

Endodontic working length from a radiograph calculator

Enter the real length of the file in the canal, its length on the radiograph, the distance from the tip to the radiographic apex and the safety margin to get the distortion, the real distance to the apex, the estimated tooth length and the working length.

Updated on

Educational tool, not medical advice: this page does not diagnose and does not replace a doctor, nurse or pharmacist. It has not been reviewed by a healthcare professional. Editorial and medical policy

Your inputs
mm

Value out of range

mm

Value out of range

mm

Value out of range

mm

Value out of range

Results

Working length

21.4 mm

Distortion of the radiograph (magnification)
7.1 %
A distortion in the usual range of up to 15 %
Real distance from the file tip to the apex
1.40 mm
The file is close to the apex
Estimated tooth length (reference point to apex)
22.4 mm

The endodontic working length calculator corrects the distortion of a radiograph and gives the real distance of a file to the apex, the estimated tooth length and the working length, from the real and imaged lengths of the file.

How the calculation works

  • Enter the real length of the file and its length on the radiograph.
  • Enter the distance from the tip to the apex on the image and the safety margin.
  • Read the working length.

Example

A file is inserted to 21 mm and measures 22.5 mm on the image, so the magnification is 7.1 %. The tip is 1.5 mm from the apex on the image, which is 1.5 × 21 / 22.5 = 1.40 mm in reality. The estimated tooth length is 22.4 mm and, with a margin of 1 mm, the working length is 21.4 mm.

Why it matters

The calculator helps dental students, general dentists and endodontists who take a working length radiograph, and assistants who prepare the files and the stops.

Good to know

The method uses a simple proportion, as the file is a ruler of known length that is seen on the same image as the apex. It assumes that the distortion is the same along the file and in the distance to the apex, which is a good approximation when the film is parallel to the root and the beam is perpendicular. If the angle is wrong, the image of a multi-rooted tooth can overlap, and a second image from a different angle helps to separate the canals. The apex of the root does not always match the end of the canal, as the main foramen is often 0.5 to 2 mm from the radiographic apex, which is the reason for a safety margin. A working length too long can push debris or irrigant beyond the root and cause pain, and one that is too short leaves infected tissue in the canal. The length of the stop on the file should be checked again, since it can move, and the length should be written on the record. This calculator is for education and the practitioner is responsible for the final length.

The anesthetic calculator treats the dose for the same patient, the crown-root ratio calculator treats the support of the tooth, the light-curing calculator treats the final restoration and the DMFT calculator treats decay.

Frequently asked questions

What is the working length?

It is the distance from a coronal reference point, such as a cusp tip, to the point where the cleaning and filling of the root canal must end. It is usually 0.5 to 1 mm short of the radiographic apex.

Why correct the radiograph?

The image of an X-ray is magnified or distorted by the position of the film and the angle of the beam. The real file length is known, so the ratio of the real to the imaged length of the file corrects the distance to the apex.

Is an apex locator better?

An electronic apex locator is accurate to within 0.5 mm in most cases and reduces exposure to radiation. The best practice is to use it with a confirming radiograph, since each method has errors.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.