Skip to content
Omnikalc

DPMO calculator: from defects to yield and sigma level

Enter the defects found, the units inspected and the opportunities per unit to get DPMO, DPU, yield and the Six Sigma level, with or without the 1.5 sigma shift.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

Results

Defects per million opportunities (DPMO)

10,800

Sigma level

3.80

Average: 3 to 4 sigma
Yield (opportunities without a defect)
98.920%
Defects per unit (DPU)
0.054
Defects per opportunity (DPO)
0.01080

Defect rates look small until they are scaled. A process with one defect in a hundred chances sounds fine, yet it produces ten thousand defects per million. This DPMO calculator turns defects, units inspected and opportunities per unit into DPMO, DPU, yield and the sigma level.

How the calculation works

  • DPU = total defects ÷ units inspected.
  • DPO = total defects ÷ (units inspected × opportunities per unit).
  • DPMO = DPO × 1,000,000.
  • Yield = (1 − DPO) × 100, the share of opportunities without a defect.
  • Sigma level = the normal quantile of (1 − DPO) plus 1.5 for the usual long-term shift. At six sigma the DPMO is 3.4.

Example

An inspection of 500 units, each with 5 chances for a defect, finds 27 defects. DPU = 27 ÷ 500 = 0.054, DPO = 27 ÷ (500 × 5) = 0.0108 and DPMO = 10,800. The yield is 98.92 % and the sigma level is about 3.80, a process that is better than average but far from six sigma.

Why it matters

Quality teams in manufacturing, software, healthcare and services use DPMO to compare processes of different size and complexity on one scale. The sigma level translates a defect rate into a number that managers know, and a project can show progress by moving from 3.5 to 4 sigma in a measurable way.

Good to know

DPMO depends on how opportunities are defined: counting more opportunities per unit lowers the DPMO without improving anything, so the definition must be fixed and honest. The 1.5 sigma shift is a convention with debated support, so state whether you use it. Small samples give wide uncertainty, so a zero-defect sample does not prove a perfect process. Use DPMO together with process capability and control charts. Teams often track it for a few critical steps rather than the whole product, which keeps the numbers meaningful and the improvement work focused.

The process capability calculator measures Cp and Cpk, the control chart calculator sets limits for monitoring a process and the confusion matrix calculator scores classification errors.

Frequently asked questions

What is DPMO?

Defects per million opportunities is the number of defects you would expect if every unit had a million chances to go wrong. It lets you compare processes with different complexity.

What is an opportunity?

A distinct place where a defect could occur and be counted, such as a solder joint, a form field or a step in an order. The count must be agreed in advance and used the same way each time.

What does six sigma mean?

A process with a short-term capability of six sigma and the 1.5 sigma long-term shift has 3.4 defects per million opportunities. Four sigma corresponds to about 6,210 DPMO and three sigma to about 66,800.

Why add 1.5 to the sigma level?

Six Sigma practice assumes a process drifts by up to 1.5 sigma over time, so the long-term and short-term levels differ. Choose no shift to see the plain statistical figure.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.