Skip to content
Omnikalc

Huffman code length calculator

Enter the frequencies of four symbols to get the average Huffman code length, the entropy, the efficiency and the size of a message.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

Value out of range

symbols

Value out of range

Results

Average Huffman code length

1.8000 bits/symbol

Entropy of the source

1.7822 bits/symbol

Coding efficiency (entropy ÷ average length)
99.01 %
Redundancy (average length − entropy)
0.0178 bits/symbol
Saving against a fixed 2-bit code
10.0 %
Message size with the Huffman code
2,250 bytes

The Huffman code length calculator gives the average Huffman code length, the entropy, the coding efficiency, the redundancy, the saving against a fixed 2-bit code and the size of a message for a source with four symbols.

How the calculation works

  • Enter the frequency of each of the four symbols, as counts or percentages.
  • Enter the length of the message in symbols.
  • Read the average length, compare it with the entropy and see the size of the encoded message.

Example

Four symbols with frequencies 45, 30, 15 and 10 have an entropy of 1.7822 bits/symbol. The Huffman code has an average length of 1.8000 bits/symbol, an efficiency of 99.01 % and a redundancy of 0.0178 bits/symbol. It saves 10.0 % against a fixed 2-bit code, so a message of 10000 symbols takes 2,250 bytes.

Why it matters

The calculator helps computer science students, programmers and engineers who study data compression, check an exercise on Huffman trees, or want to know how close a prefix code gets to the entropy limit before they choose a coding scheme for a protocol or a file format.

Good to know

Use the real frequencies of the symbols in your data, as counts or percentages, all greater than zero. The result is the average length of an optimal code symbol by symbol, and it does not include the cost of storing the code table or the header. Real data often have dependencies between symbols that arithmetic coding or dictionary methods exploit better. For more than four symbols, the same merging procedure applies, but this calculator is limited to four.

The Shannon entropy calculator gives the theoretical limit for any number of symbols, the data encoding overhead calculator shows the cost of an encoding, the parity bit calculator adds error detection and the combinations calculator counts possible messages.

Frequently asked questions

What is a Huffman code?

A Huffman code is an optimal prefix code: it gives short bit strings to frequent symbols and long ones to rare symbols, so that the average length is as small as possible for symbol-by-symbol coding. It is built by repeatedly merging the two least frequent items into one until a single tree remains.

How is the average length computed here?

For four symbols the Huffman algorithm makes three merges. The average code length equals the sum of the weights of the merged nodes, divided by the total, plus one for the root. The calculator sorts the frequencies, merges the two smallest, then merges again the two smallest of the three remaining items.

How does it compare with the entropy?

The entropy H is the theoretical lower bound for the average length of any symbol code, and Huffman coding always satisfies H ≤ L < H + 1. The two are equal only when all probabilities are powers of one half. The gap is the redundancy, which can be reduced by coding blocks of symbols.

Does the code depend on the exact frequencies?

Only on their order and relative sizes. Ties can produce different trees, but the average length is always the same. Using the real frequencies of your data gives the best result, and a code built for one source performs poorly if the statistics change.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.