Skip to content
Omnikalc

Boiling point elevation calculator: how hot does a solution boil?

Choose the solvent, enter the molality and the van't Hoff factor to get the boiling point elevation and the new boiling point in degrees Celsius and Fahrenheit.

Updated on
Your inputs
mol/kg

Value out of range

Value out of range

Results

New boiling point

101.02 °C

Boiling point elevation
1.024 °C
New boiling point in °F
213.8 °F
Elevation in °F
1.84 °F

A solution always boils at a higher temperature than the pure liquid. This boiling point elevation calculator takes the solvent, the molality of the solute and the van’t Hoff factor to give the boiling point elevation and the new boiling point in degrees Celsius and Fahrenheit.

How the calculation works

  • Boiling point elevation ΔTb = i × Kb × m, where i is the van’t Hoff factor, Kb is the ebullioscopic constant of the solvent in °C·kg/mol and m is the molality in mol/kg.
  • New boiling point = boiling point of the pure solvent + ΔTb.
  • Constants used: water 0.512 °C·kg/mol, ethanol 1.22, benzene 2.53 and acetic acid 3.07, with pure boiling points of 100, 78.37, 80.1 and 118.1 °C.
  • Fahrenheit values multiply the Celsius numbers by 1.8, and add 32 for a temperature.

Example

A 1 mol/kg solution of table salt in water has i = 2, since NaCl gives two ions. The elevation is 2 × 0.512 × 1 = 1.024 °C, so the solution boils at 100 + 1.024 = 101.02 °C, which is 213.8 °F. Salting your pasta water therefore raises the boiling point by less than 1 °C.

Why it matters

Boiling point elevation explains why antifreeze also protects an engine from boiling, why salt water boils slightly hotter and why a sugar syrup is hotter than water at the same pressure. It is also used to measure the molar mass of an unknown solute, and in chemistry classes as a standard example of a colligative property.

Good to know

The equation assumes a dilute, ideal solution with a non-volatile solute, so it does not work when the solute evaporates, as alcohol in water does. The constant Kb belongs to the solvent and does not change with the solute. Atmospheric pressure sets the boiling point of the pure solvent, so at altitude both the base value and the result fall by the same amount. Molality is used because, unlike molarity, it does not change with temperature.

The freezing point calculator gives the matching depression, the molality calculator converts a mass to moles per kilogram and the Clausius-Clapeyron calculator links boiling point to pressure.

Frequently asked questions

What is boiling point elevation?

It is the rise in the boiling point of a liquid when a non-volatile substance is dissolved in it. It is a colligative property, which means that it depends on the number of dissolved particles, not on what they are.

What is the van't Hoff factor?

It is the number of particles that one formula unit gives in solution: 1 for sugar, about 2 for NaCl, about 3 for CaCl₂. Real solutions give slightly lower values than the ideal, because ions attract each other.

Does salt in pasta water matter?

Very little. A tablespoon of salt in several liters of water raises the boiling point by a fraction of a degree. Salt is added for taste, not to cook faster.

Is the formula valid for concentrated solutions?

It is accurate for dilute solutions, roughly below 1 mol/kg. At higher concentrations the interaction between particles makes the real elevation differ from the calculation.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.