Skip to content
Omnikalc

How fast does water flow through the ground?

Enter the hydraulic conductivity, the area, the head difference, the path length and the porosity: get the discharge, the Darcy and seepage velocities and the travel time.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

Value out of range

%

Value out of range

Results

Discharge

0.03 L/s

Seepage velocity (actual water speed in the pores)

5.184 m/day

Hydraulic gradient
0.1500
A permeable material, such as sand
Discharge per day
2.59 m³/day
Darcy velocity (specific discharge)
1.296 m/day
Travel time over the flow path
1.9 days

Darcy’s law describes how water moves through soil, sand, rock or a filter. The flow is driven by the difference in water level between two points, and resisted by the material, which is described by its hydraulic conductivity. This calculator gives the discharge, the Darcy velocity, the real seepage velocity in the pores and the travel time along a given path.

How the calculation works

  • Hydraulic gradient i = head difference ÷ flow length
  • Discharge Q = K × A × i
  • Darcy velocity q = K × i
  • Seepage velocity v = q ÷ porosity
  • Travel time = flow length ÷ seepage velocity

Example

Water flows through a sand with a conductivity of 0.01 cm/s (10⁻⁴ m/s) over a cross-section of 2 m². The head drops by 1.5 m over 10 m, so the gradient is 0.15. The discharge is 0.03 L/s, or 2.59 m³ per day. The Darcy velocity is 1.30 m/day, and with a porosity of 25%, the seepage velocity is 5.18 m/day. A drop of water takes about 1.9 days to cross the 10 m.

Where it is used

Hydrogeologists estimate groundwater flow, well yields and the spread of contaminants. Civil engineers use it for seepage under dams and around excavations, for drainage and filter design, and for the settlement of soils under load. Gardeners and landscapers use the same ideas to judge how well a soil drains.

Good to know

Hydraulic conductivity differs between a soil’s horizontal and vertical directions, and it changes with temperature because the viscosity of water changes. The law assumes saturated, laminar flow. Layered soils behave like a combination of layers, and clay barriers can be millions of times less permeable than sand. For a real project, use field tests and a qualified engineer, especially near structures and slopes.

For the flow in pipes, use the friction loss and pipe flow velocity calculators. The French drain calculator sizes a drainage trench, and the Reynolds number calculator tells you if a flow is laminar.

Frequently asked questions

What does Darcy's law say?

That the flow of water through a porous material is proportional to the hydraulic conductivity, the cross-sectional area and the hydraulic gradient: Q = K × A × (Δh ÷ L).

What is the difference between the Darcy velocity and the seepage velocity?

The Darcy velocity is the discharge divided by the full area. Water only passes through the pore space, so the real speed in the pores, the seepage velocity, is the Darcy velocity divided by the porosity.

Where does it apply?

To laminar flow in saturated soil, sand, rock and filters at low speeds. It fails for very fast, turbulent flow in coarse gravel and for very tight clays at very low gradients.

How do I find the hydraulic conductivity?

From a permeability test in a lab or a field test such as a pumping or a slug test, or from tables for the soil type. It varies by many orders of magnitude, so a field measurement is best.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.