A source and a load that do not have the same impedance reflect part of the power. The impedance matching calculator gives two classical solutions: a quarter-wave transformer (the impedance and the length of the line section) and a low-pass L-network (the series inductor and the shunt capacitor). It also shows the SWR and the mismatch loss without matching.
How the calculation works
- Enter the source impedance, the load impedance, the frequency and the velocity factor of the line.
- A quarter-wave transformer is a section of line, a quarter of a wavelength long, with the impedance Z = √(Rs × RL).
- An L-network has a series inductor on the low-impedance side and a shunt capacitor on the high-impedance side, with Q = √(R_high / R_low − 1), X_L = Q R_low and X_C = R_high / Q.
- The calculator also gives the SWR and the mismatch loss that you would have without any matching.
Example
To match a 50 Ω source to a 200 Ω load at 14.2 MHz, a quarter-wave transformer needs a line of 100 Ω, 11.43 ft long for a velocity factor of 0.66. The L-network has Q = 1.732, a series inductor of 970.6 nH and a shunt capacitor of 97.06 pF. Without matching, the SWR is 4:1 and the mismatch loss is 1.938 dB.
Why it matters
Matching is needed in antennas, amplifiers, filters and transmission lines, wherever two parts of different impedance meet. The two methods here are the first tools of a radio amateur and of an RF designer, and they give the starting values for a more detailed design.
Good to know
The calculator is for purely resistive source and load, at a single frequency. The quarter-wave transformer is exact only at its design frequency, and the L-network values assume ideal components with no losses and no parasitic elements, which matters above about 100 MHz. If the load has a reactive part, it must be tuned out first. The length of the line section uses the velocity factor entered, and for a very high frequency, the effects of the layout must be taken into account.
Related tools
The SWR calculator gives the standing wave ratio and the return loss of any mismatch, the coax electrical length calculator cuts a cable to the right length, the RC filter calculator covers the other use of reactive components, and the RLC impedance calculator covers the impedance of reactive networks.