Skip to content
Omnikalc

Probit analysis calculator (LD50)

Enter two doses and the share of subjects that responded at each to get the slope of the probit line, the dose that affects half of the subjects (LD50 or ED50) and the doses for 10 % and 90 %.

Updated on
Your inputs

Value out of range

%

Value out of range

Value out of range

%

Value out of range

%

Value out of range

Results

Median effective dose (LD50 or ED50)

25.106

Dose for 10 % response
8.044
Dose for 90 % response
78.364
Dose for the extra target response
108.206
Within a reasonable distance of the tested doses
Slope of the probit line
2.592
Typical slope
Spread, dose for 90 % over dose for 10 %
9.74 ×

The probit analysis calculator gives the LD50, the doses for 10 % and 90 % and the slope of the probit line from two dose-response points.

How the calculation works

  • Enter the two doses and the share of subjects responding at each.
  • Optionally enter an extra target response.
  • The calculator gives the median dose, the 10 % and 90 % doses, the target dose, the slope and the spread.

Example

At a dose of 10, 15 % of the subjects respond, and at 40, 70 % do. The probits are −1.036 and 0.524, so the slope is (0.524 + 1.036) / (log 40 − log 10) = 2.592 per log unit. The median dose is 10^(1 + 1.036 / 2.592) = 25.106. The doses for 10 % and 90 % are 8.044 and 78.364, which is a spread of 9.74 times.

Why it matters

The calculator helps toxicology and pharmacology students, biologists who test pesticides or drugs, and environmental scientists who estimate effect concentrations.

Good to know

The method assumes that the tolerance of subjects follows a log-normal distribution and that the dose is the only cause of the response. Use at least one point below and one above 50 % to interpolate rather than extrapolate. Spontaneous responses in controls can be corrected with Abbott’s formula before the analysis. The calculator is meant for teaching and quick estimates, not for safety classification, which follows regulatory protocols. Use doses on a comparable basis, such as mg per kg of body weight, and report the unit with the result. Also state how the response was defined and the exposure time, since the LD50 changes with both, and give the species or the system tested.

The EC50 Hill equation calculator models a sigmoid response, the normal distribution calculator gives the probit values, the logarithm calculator handles log doses and the half-life calculator treats elimination.

Frequently asked questions

What is probit analysis?

It models how the share of subjects that respond rises with the dose. The shares are converted with the inverse of the normal distribution (the probit) and plotted against the logarithm of the dose, which gives a straight line when the tolerances are log-normal.

What is the LD50?

The LD50 is the dose that kills half of the test subjects. The same idea gives the ED50 for an effect and the EC50 for a concentration. It is a median, so it is less affected by extreme individuals than a mean would be.

How good is a two-point estimate?

It is a quick interpolation, not a fit. A real analysis uses at least four or five doses, weights the points and gives confidence limits. Responses of exactly 0 % or 100 % cannot be used.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.