Skip to content
Omnikalc

Signal-to-noise ratio calculator: how clean is your signal?

Enter the signal and noise voltages and the bandwidth to get the SNR in dB, the power ratio, the effective number of bits and the Shannon capacity.

Updated on
Your inputs

Value out of range

Value out of range

Hz

Value out of range

Results

Signal-to-noise ratio

60.0 dB

High SNR, typical of good audio and measurement equipment
Voltage ratio, signal to noise
1,000
Power ratio, signal to noise
1,000,000
Effective number of bits for a converter
9.67 bits
Shannon capacity of the channel
61.8 kbit/s

Every measurement and every communication link has a signal you want and noise you don’t. The signal-to-noise ratio (SNR), in decibels, tells you how much stronger one is than the other. This calculator turns two RMS voltages into the SNR, the power ratio, the effective number of bits of an analog-to-digital converter, and the Shannon capacity of a channel with a given bandwidth.

How the calculation works

  • SNR (dB) = 20 × log10(signal voltage ÷ noise voltage)
  • Power ratio = (signal voltage ÷ noise voltage)²
  • Effective number of bits = (SNR − 1.76) ÷ 6.02
  • Shannon capacity = bandwidth × log2(1 + power ratio)

The factor of 20 applies to voltages and 10 to powers: both give the same decibel value for the same signal.

Example

A 1 V signal with 1 mV of noise has a voltage ratio of 1,000. The SNR is 60 dB and the power ratio is 1,000,000. A converter that sees this SNR has about 9.67 effective bits. On a telephone-grade channel with a bandwidth of 3,100 Hz, the Shannon capacity is about 61.8 kbit/s.

Why it matters

SNR sets the quality of an audio recording, the range of a radio link and the accuracy of a sensor. Increasing it by 6 dB doubles the voltage ratio and adds one bit of resolution. It also shows the limits of data rates: no coding scheme can beat the Shannon capacity, so improving the SNR or the bandwidth is the only way to send more data on a channel.

Good to know

Noise comes from the electronics (thermal noise), the environment (interference) and the quantization of a converter. Use RMS values; peak values give a different number. For signals with a wide dynamic range, a weighted measure such as A-weighting is used for audio. The 1.76 and 6.02 constants assume a full-scale sine wave. This tool is for education.

The decibel addition calculator combines levels, the Nyquist sampling calculator checks the sampling rate, and the op-amp gain calculator designs amplifier stages.

Frequently asked questions

What is the signal-to-noise ratio?

It compares the strength of a wanted signal to that of the background noise, usually in decibels. A higher ratio means a cleaner signal. A ratio of 0 dB means signal and noise have equal power.

How is SNR calculated from voltages?

SNR in dB is 20 times the base-10 logarithm of the signal voltage divided by the noise voltage, both measured as RMS. Using power instead, the factor is 10 rather than 20. Every 20 dB is a factor of 10 in voltage.

What is the effective number of bits?

It is the resolution a converter really delivers once noise is counted: (SNR − 1.76) ÷ 6.02. A 60 dB SNR is worth about 9.7 bits, whatever the converter's nominal bit depth.

What does Shannon capacity mean?

It is the highest rate at which data can be sent over a noisy channel with no errors in theory: bandwidth × log2(1 + signal power ÷ noise power). It is a limit; practical systems approach it with coding.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.