Skip to content
Omnikalc

How fast does the car go at a given engine speed?

Enter the engine speed, the gear ratio, the final drive and the tire diameter: get the road speed, the wheel speed and the rpm needed for a target speed.

Updated on
Your inputs
rpm

Value out of range

Value out of range

Value out of range

Value out of range

Value out of range

Results

Road speed (mph)

91.7

Road speed (km/h)
147.6
Wheel speed (rpm)
1,142
Engine speed needed for the target road speed (rpm)
2,126

At what speed does a car run in a given gear at a given rpm? The answer follows from the gear ratio, the final drive ratio and the tire diameter. This calculator converts the engine speed into wheel speed and road speed, and also gives the rpm needed to hold a target speed, which helps in choosing a gear, a final drive or a tire size.

How the calculation works

  • Wheel speed (rpm) = engine rpm ÷ (gear ratio × final drive ratio)
  • Road speed = wheel speed × π × tire diameter
  • Engine speed at a target speed = target speed ÷ road speed × rpm

Example

At 3,000 rpm in a gear with a ratio of 0.74, a final drive of 3.55 and tires of 27 in (686 mm), the wheels turn at 1,142 rpm. The road speed is 91.7 mph, or 147.6 km/h. To drive at 65 mph the engine needs about 2,126 rpm.

Why it matters

Gearing decides the balance between acceleration and economy: a lower final drive gives a lower engine speed at cruise, which saves fuel and noise, while a higher one improves acceleration. The same arithmetic is used to check the speedometer after changing tires, to design gear sets for racing and to see what speed an engine reaches at its redline.

Good to know

Tires grow slightly under centrifugal force at speed and wear changes the diameter, so the real speed differs by a percent or two. The calculation assumes no wheelspin or clutch slip and a single fixed ratio, so it does not apply to a continuously variable transmission unless you enter its actual ratio. Automatic transmissions with a torque converter also slip a little, especially in lower gears and at low speed, so the figure is most accurate in the top gear with the converter locked. This tool is for education.

The tire size calculator compares two tire sizes, the gear ratio calculator covers gear trains, and the horsepower and torque calculator relates torque and speed to power.

Frequently asked questions

How is road speed computed from rpm?

The engine speed is divided by the gear ratio and the final drive ratio to get the wheel speed, which is multiplied by the tire circumference. Speed = wheel rpm × π × tire diameter.

Where do I find the gear and final drive ratios?

In the owner's manual or the manufacturer's specifications. The final drive ratio is often written as 3.55:1, and each gear has its own ratio, with overdrive gears below 1.

How do I get the tire diameter?

From the tire size, for example 225/45 R17: the sidewall height is 225 × 0.45 = 101 mm, and the diameter is 2 × 101 + 17 × 25.4 = 634 mm. The tire size calculator does this for you.

Why is the speedometer reading different?

Worn tires are smaller than new ones, and a change of tire size or final drive changes the relation between rpm and speed. Speedometers are also set to read slightly high by regulation.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.