Skip to content
Omnikalc

How far from the target should you start the descent?

Enter the cruise and target altitudes, the ground speed and the descent angle: get the distance to start descending, the time, the rate of descent and the 3:1 estimate.

Updated on
Your inputs
ft

Value out of range

ft

Value out of range

Value out of range

°

Value out of range

Results

Distance from the target at which to start the descent

100.5 NM

Time of the descent
14.4 min
Required rate of descent
2,229 ft/min
A normal descent rate
Distance by the 3:1 rule of thumb
96 NM
Altitude to lose
32,000 ft

When should you start down so as to arrive at the right altitude at the right place? The classic answer is the 3:1 rule, but it works for only one angle. This calculator gives the distance from the target at which to begin the descent, the time it takes and the rate of descent to hold from the altitude to lose, the ground speed and the descent angle.

How the calculation works

  • Altitude to lose = cruise altitude − target altitude
  • Distance = altitude to lose ÷ (tan(angle) × 6,076 ft per NM)
  • Rate of descent (ft/min) = ground speed (kt) × 101.27 × tan(angle)
  • Time = distance ÷ ground speed × 60
  • 3:1 rule = thousands of feet to lose × 3 NM

Example

An aircraft descends from 35,000 ft to 3,000 ft, so it loses 32,000 ft. On a 3 degree path, the descent should start 100.5 NM from the target. At a ground speed of 420 kt, that takes 14.4 minutes at a rate of about 2,229 ft/min. The 3:1 rule gives 96 NM, close to the exact figure.

Why it matters

Planning the descent keeps the flight stable, saves fuel by avoiding level segments at low altitude, and avoids rushed, steep approaches. The same arithmetic is used for stepping down to a minimum altitude, for drones and for checking the glide path of an approach.

Good to know

This calculator is a training aid. Real descents follow air traffic control instructions, published procedures, speed restrictions and the aircraft’s performance, and the pilot must use the approved flight planning tools. Winds change the ground speed, and the angle may vary with the configuration. Passenger aircraft usually descend at the idle thrust setting on a path of about 3 degrees, and speed restrictions near the destination mean the planned path is adjusted along the way. This tool is for education.

The glide distance calculator gives the range of an unpowered aircraft, the wind triangle calculator provides ground speed and heading, and the true airspeed calculator converts indicated speed at altitude.

Frequently asked questions

What is the top of descent?

The point on the route where the aircraft starts to descend so as to reach a target altitude at a chosen place, such as an approach fix. Flying a constant descent angle from this point gives a smooth, fuel-efficient approach.

What is the 3:1 rule?

A rule of thumb: for each 1,000 feet to lose, start the descent 3 nautical miles away. It corresponds to a path of about 3 degrees. The exact figure is 3.15 NM per 1,000 ft.

How is the rate of descent estimated?

For a 3 degree path, the rate in feet per minute is about five times the ground speed in knots. A ground speed of 420 knots means roughly 2,100 ft/min; the calculator gives the exact value.

Does wind change the result?

Wind changes the ground speed, which is why the calculator takes the ground speed and not the airspeed. A headwind lowers the rate needed, and a tailwind raises it.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.