Skip to content
Omnikalc

Fault tree top event calculator

Enter the probability of four independent basic events and choose how the gates combine them to get the probability of the top event.

Updated on
Your inputs
%

Value out of range

%

Value out of range

%

Value out of range

%

Value out of range

Results

Probability of the top event

0.1350 %

One chance in
741
Rare-event approximation (sum of the cut sets)
0.1350 %
Error of the rare-event approximation
0.03 %
Number of minimal cut sets
2

The fault tree calculator gives the probability of the top event from four independent basic events combined by AND and OR gates, with the rare-event approximation for comparison.

How the calculation works

  • Enter the probability of the four basic events A, B, C and D.
  • Choose the structure of the gates.
  • The calculator gives the probability of the top event, the one-in-N odds, the rare-event approximation, its error and the number of cut sets.

Example

With probabilities of 2 %, 3 %, 1.5 % and 5 % and the structure (A and B) or (C and D), the top event is 1 − (1 − 0.02 × 0.03)(1 − 0.015 × 0.05) = 0.1350 %, or 1 in 741. The sum of the cut sets, 0.06 % + 0.075 %, gives 0.1350 %, an error of 0.03 %.

Why it matters

The calculator helps safety engineers, reliability analysts and students to see how redundancy and series arrangements change the chance of a system failure, for example a pump with a backup or an alarm chain.

Good to know

Read AND gates as redundancy: both channels must fail for the system to fail, so the probability drops sharply. Read OR gates as single points of failure: any one event is enough, so the probabilities add up. Compare the structures to see why a series of four parts is much less safe than two redundant pairs. The probability of each basic event must be for the same period, for example one year or one demand, and can come from the failure rate λ with p = 1 − e^(−λt). If a single event, such as a power cut, feeds several branches, the independence assumption fails and the real probability is higher. In that case model the shared event separately in a full fault tree tool.

The system reliability calculator combines series and parallel components, the MTBF and availability calculator gives failure rates, the probability calculator handles basic events and the risk reward calculator compares gains and losses.

Frequently asked questions

How are the gates computed?

For independent events, an AND gate multiplies the probabilities, because all inputs must occur, and an OR gate gives 1 − (1 − p1)(1 − p2)…, the chance that at least one occurs. The calculator applies these two rules to the structure you pick, which gives the exact probability of the top event.

What is a minimal cut set?

A minimal cut set is a smallest group of basic events whose joint occurrence causes the top event. In (A and B) or (C and D), the cut sets are the pair A and B and the pair C and D. When the probabilities are small, the sum of the products of the cut sets is a good and slightly conservative approximation.

What are the limits of this model?

The basic events must be independent, with no common cause and no dependency between them, and the probability must refer to the same time period or demand. Common cause failures can dominate the real risk, and they are not captured here. The structures are fixed to four events, so use a full tool for large trees.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.