Skip to content
Omnikalc

Torsion pendulum calculator

Enter the wire material, its diameter and length and the mass and radius of the disc to get the torsion constant, the period and the frequency.

Updated on
Your inputs
mm

Value out of range

m

Value out of range

kg

Value out of range

cm

Value out of range

Results

Period of oscillation

3.545 s

Frequency
0.282 Hz
Torsion constant of the wire
0.01571 N·m/rad
Moment of inertia of the disc
0.00500 kg·m²
Torque for a quarter turn of twist
0.0247 N·m

The torsion pendulum calculator gives the torsion constant of a wire, the moment of inertia of a disc and the period and the frequency of the twisting oscillation.

How the calculation works

  • Pick the wire material, which sets the shear modulus.
  • Enter the diameter and the length of the wire.
  • Enter the mass and the radius of the disc.
  • The calculator gives the period, the frequency, the torsion constant, the inertia and the torque for a quarter turn.

Example

A steel wire of 1 mm and 0.5 m gives κ = π × 80 × 10⁹ × (0.001)⁴ / (32 × 0.5) = 0.01571 N·m/rad. A 1 kg disc of 10 cm radius has I = ½ × 1 × 0.1² = 0.00500 kg·m². The period is 2π √(0.00500 / 0.01571) = 3.545 s, a frequency of 0.282 Hz.

Why it matters

The calculator helps physics students and teachers to design a torsion experiment, to estimate a shear modulus from a measured period and to size a wire for a slow, steady oscillator.

Good to know

To measure the shear modulus of a wire, time several periods of a disc of known inertia and invert the formula: G = 32 L I (2π/T)² / (π d⁴). The diameter has the largest effect because it is raised to the fourth power, so measure it with a micrometer at several points. A torsion pendulum is a good timekeeper because its period depends on the inertia and the wire only, not on gravity, and the same device can be used in space. Keep the twist small, a few degrees up to a few tens, so that the wire stays elastic and the motion remains harmonic. For a fishing line, expect a long period and a strong damping from the plastic.

The physical pendulum calculator covers swinging bodies, the shaft torsion calculator gives the twist of a loaded shaft, the moment of inertia calculator gives the inertia of other shapes and the simple harmonic motion calculator describes the oscillation.

Frequently asked questions

How do you find the torsion constant of a wire?

For a round wire the torsion constant is κ = π G d⁴ / (32 L), where G is the shear modulus of the material, d the diameter and L the length. It means that the torque grows with the fourth power of the diameter, so a wire twice as thick is sixteen times as stiff, and a longer wire is softer in proportion.

What is the formula of the period?

The period is T = 2π √(I / κ), where I is the moment of inertia of the disc about the wire axis. For a solid disc I = ½ m r². The period does not depend on the angle of twist as long as the wire stays elastic, which is why torsion pendulums are used in clocks and in the Cavendish experiment.

What are the limits of the model?

The wire must stay in its elastic range and carry the load without stretching, the mass of the wire is ignored, and the damping from the air and the wire is small. The shear modulus depends on the alloy, so use the value as a typical one and measure the period of the real device to calibrate it.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.