Skip to content
Omnikalc

How much does your shaft twist?

Enter the torque, the diameter, the length and the material: get the maximum shear stress, the angle of twist, the torsional stiffness and the power transmitted.

Updated on
Your inputs

Value out of range

Value out of range

Value out of range

Value out of range

rpm

Value out of range

Results

Maximum shear stress at the surface

20.37 MPa

Angle of twist over the length

0.591 °

Twist per metre
0.591 °/m
Acceptable for most machine shafts: up to 1° per metre
Polar moment of area J
613,592 mm⁴
Torsional stiffness
48,474 N·m/rad
Power transmitted at this speed
78.54 kW

A shaft that transmits power is twisted by the torque. Two things matter to an engineer: the shear stress in the material, which sets the strength, and the angle of twist, which sets the stiffness. This calculator gives both for a solid round shaft, plus the polar moment of area, the torsional stiffness and the power transmitted at a given rotation speed.

How the calculation works

  • Polar moment of area J = π × d⁴ ÷ 32
  • Maximum shear stress τ = 16 × T ÷ (π × d³), at the surface
  • Angle of twist φ = T × L ÷ (G × J), in radians, then converted to degrees
  • Torsional stiffness = T ÷ φ
  • Power = T × 2π × rpm ÷ 60

Example

A steel shaft of 50 mm diameter and 1 m length carries 500 N·m at 1,500 rpm, with a shear modulus of 79 GPa. The polar moment is 613,592 mm⁴. The shear stress at the surface is 20.4 MPa and the shaft twists 0.591°, or 0.591° per metre. The stiffness is about 48,474 N·m/rad, and the shaft transmits 78.5 kW.

Where it is used

Drive shafts, axles, screwdriver bits, torsion bars and motor shafts all work in torsion. The same relations size a shaft for a motor, check that a long shaft does not twist too much, and compare solid and hollow designs. Compare the shear stress with the allowable shear stress of the material, about half the yield strength for steel, and add a safety factor.

Good to know

The formulas apply to a circular section with a constant torque. Keyways, shoulders and holes add stress concentrations, and bending and axial loads combine with the torsion. For rapidly changing loads, fatigue limits the allowable stress far below the static value. A shaft supported by bearings must also be checked for critical speed and bending.

For the torque of a motor at a given power, use the motor speed and torque calculators. For bending, try the beam deflection calculator, and for the combined state of stress at a point, the principal stress calculator.

Frequently asked questions

What is the polar moment of area?

A geometric property that measures how well a cross section resists twisting. For a solid round shaft, J = π × d⁴ ÷ 32. Doubling the diameter multiplies it by 16.

Why does the diameter matter so much?

The shear stress falls with the cube of the diameter, and the twist angle with the fourth power. A small increase in diameter gives a large gain in strength and stiffness.

What twist is acceptable?

It depends on the use. Precision drives are kept below about 0.25° per metre, and common machine shafts up to about 1° per metre. Long drive shafts can accept more if the load is steady.

What about hollow shafts?

A hollow shaft carries torque more efficiently for its weight, because the material near the centre does little. This calculator covers solid round shafts only.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.