Skip to content
Omnikalc

How much distortion does your signal have?

Enter the amplitude of the fundamental and of the 2nd to 5th harmonics: get the total harmonic distortion in percent and in dB, and the level of the fundamental above the harmonics.

Updated on
Your inputs
V

Value out of range

V

Value out of range

V

Value out of range

V

Value out of range

V

Value out of range

Results

Total harmonic distortion (THD)

2.739%

Audible on some material; acceptable for a loudspeaker
THD in decibels
-31.2 dB
Fundamental above the harmonics
31.2 dB
Fundamental as a share of the total signal
99.96%

When you feed a pure sine wave into an amplifier, a loudspeaker or any other device, the output is never perfectly pure. Small copies of the signal appear at whole-number multiples of its frequency: the harmonics. The total harmonic distortion (THD) is the size of those unwanted harmonics relative to the wanted fundamental. It is a standard figure on audio and power electronics data sheets.

How the calculation works

  • THD = √(V₂² + V₃² + V₄² + V₅²) ÷ V₁ × 100
  • In decibels = 20 × log₁₀(THD ÷ 100)
  • Fundamental above harmonics = −20 × log₁₀(THD ÷ 100)

Here V₁ is the fundamental and V₂ to V₅ are the harmonics, all measured in the same unit. The harmonics add as the square root of the sum of their squares, because they are at different frequencies.

Example

A fundamental of 1 V with harmonics of 0.02, 0.015, 0.01 and 0.005 V gives √0.00075 = 0.0274, so the THD is 2.74%, or −31.2 dB. The fundamental is about 31.2 dB above the harmonic content, and it forms 99.96% of the total signal’s amplitude.

What distortion sounds like

Even harmonics (2nd, 4th) tend to sound warm and are less objectionable, while odd harmonics (3rd, 5th) sound harsher. Distortion also changes with level: it generally increases at high output, near clipping. A single THD figure at one power level does not tell the whole story, so check the conditions of the measurement.

Measuring it

THD is measured with a spectrum analyzer or an audio analyzer, using a clean test tone. List the harmonics up to the fifth, or more for fine work. Because higher harmonics are typically much smaller, the first few dominate the result.

Reducing distortion

Distortion in an amplifier usually falls when you add negative feedback, lower the output level or choose a part with more headroom. In a loudspeaker, a larger driver working at a lower excursion distorts less. Keep in mind that a low THD figure does not guarantee a good sound, since the ear is also sensitive to other characteristics such as frequency response.

Frequently asked questions

What is THD?

Total harmonic distortion: the ratio of the combined amplitude of the harmonics to the amplitude of the fundamental, usually in percent.

What is a good THD?

Below 1% is considered inaudible for most listeners, and good amplifiers reach 0.01% or less. Loudspeakers typically measure 0.5% to 5%.

Is amplitude in volts required?

Any unit works, as long as all values use the same unit: volts, millivolts or sound pressure.

What about noise?

THD+N also counts noise. This calculator uses harmonics only.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.