Skip to content
Omnikalc

Wingate test calculator: peak power, mean power and fatigue index

Enter your body mass, the resistance and the pedal revolutions to get the peak power, the mean power, the lowest power and the fatigue index of the test.

Updated on
Your inputs

Value out of range

%

Value out of range

Value out of range

Value out of range

Value out of range

m

Value out of range

Results

Peak power

793 W

Relative peak power
10.59 W/kg
Lowest power
396 W
Mean power over 30 seconds
595 W
Relative mean power
7.95 W/kg
Fatigue index
50.0%
Moderate fatigue
Total work
17.8 kJ

This calculator is for general information and education. It is not medical advice and does not replace the advice of your doctor or a registered dietitian.

For sprinters, cyclists and team-sport players, the power in the first seconds and the ability to hold it count more than endurance. This Wingate test calculator takes your body mass, the resistance, the pedal revolutions in the best and last 5 seconds and over the full 30 seconds, and the flywheel distance to give the peak power, the relative peak power, the lowest power, the mean power, the fatigue index and the total work.

How the calculation works

  • Load = body mass × resistance share × 9.81, in newtons. The standard resistance for the Wingate test is 7.5% of body mass, or 0.075 kg per kg.
  • Peak power = load × flywheel distance per revolution × revolutions in the best 5 seconds ÷ 5. Lowest power uses the revolutions in the last 5 seconds.
  • Mean power = load × distance per revolution × total revolutions ÷ 30. Total work = load × distance per revolution × total revolutions, in kilojoules.
  • Fatigue index = (peak power − lowest power) ÷ peak power × 100. Relative power is the power divided by body mass.

Example

A cyclist weighing 165 lb (74.8 kg) rides the Wingate test at 7.5% of body mass, a load of 74.8 × 0.075 × 9.81 = 55.1 N. In the best 5 seconds they make 12 revolutions of a 6 m flywheel, which is a peak power of 55.1 × 6 × 12 ÷ 5 = 793 W, or 10.6 W/kg. In the last 5 seconds they make 6 revolutions, a power of 397 W, so the fatigue index is 50%. With 54 revolutions in 30 seconds, the mean power is 595 W and the total work is 17.8 kJ.

Why it matters

Sports scientists, coaches and physiologists use the test to compare athletes, to select players and to monitor the effects of training and of a recovery after injury. The values are also used in research on anaerobic performance.

Good to know

The test is exhausting, and people with a heart condition or a lack of training should have medical advice before they try it. Results depend on the ergometer, the seat height, the warm-up, the start and the motivation of the athlete. This calculator uses the counted revolutions, and an electronic system with continuous sampling will give higher peak values. Compare only tests made under the same conditions.

The cycling power calculator estimates the power of rides on the road, the sprint velocity calculator measures running speed and the VO2 max calculator covers the aerobic side of fitness.

Frequently asked questions

What is the Wingate test?

The Wingate anaerobic test is a 30 second all-out cycling sprint against a constant resistance. It is the most common test of anaerobic power and capacity, the ability to produce energy without oxygen over a short time. The athlete pedals as hard as possible, and the revolutions are counted every 5 seconds.

What resistance should I use?

The standard is 7.5% of body mass for the general population, which is 0.075 kg of load per kg. Some researchers use 8.5% to 10% for highly trained sprint athletes. The calculator takes the percentage you choose, and the load is turned into a force by multiplying by 9.81.

What is the fatigue index?

The fatigue index shows how much power drops during the test, the difference between the peak and the lowest 5 second power as a share of the peak. A low index means the athlete holds power well, and a high index means the power fades quickly. The labels shown are broad guidance.

How do I count the revolutions?

A computer, a sensor or a person counts the pedal revolutions in each 5 second window. The best window gives the peak power and the last window gives the lowest power. For a Monark ergometer one pedal revolution moves the flywheel 6 m, and other ergometers use other values that you can enter.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.