Skip to content
Omnikalc

How tall should a mailbox post be?

Enter the height of the mailbox bottom above the road, the mount thickness, the depth in the ground, the post size, the hole diameter and the concrete bag yield: get the post above ground, the post length, the concrete and the bags.

Updated on
Your inputs
in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

cu ft

Value out of range

Results

Post length

64 in

Concrete bags

3

USPS asks for the bottom of the box 41 to 45 in above the road and its front 6 to 8 in back from the curb; check with your post office before you dig, and call 811 to locate buried lines
Post above ground
40.0 in
Concrete
0.92 cu ft

A curbside mailbox must sit at the right height for the mail carrier to reach it from the vehicle, and its post must be buried deep enough to stand straight for years. This calculator works out the post height above ground, the total post length, the concrete for the hole and the number of bags.

How the calculation works

  • Post above ground = height of the mailbox bottom − mount or arm thickness
  • Post length = post above ground + depth in the ground
  • Concrete = hole volume (π × diameter² ÷ 4 × depth) − the post’s own volume below ground
  • Bags = concrete ÷ yield per bag, rounded up

For a mailbox bottom 42 in above the road, sitting on a 2 in mount, the post stands 40 in out of the ground. Buried 24 in, it must be 64 in long. A 10 in hole around a 4 × 4 post (3.5 in actual) takes about 0.92 cu ft of concrete, or 3 bags of 0.375 cu ft.

USPS guidelines

Item Guideline
Height of the box bottom or door 41 to 45 in above the road surface
Setback front of the box 6 to 8 in back from the curb or road edge
House number on the box or post, visible from the road

Your local postmaster has the final word, so ask before installing a new box, especially on a new road. Boxes must also be an approved design.

Choosing the post

  • 4 × 4 treated lumber is the most common, often with a short arm to hold the box over the road edge.
  • Steel posts last longer and come with brackets for standard boxes.
  • Breakaway designs are safer: many states recommend posts that bend or break if a car hits them, and discourage brick pillars or heavy steel along fast roads.

Setting the post

  1. Call 811 a few days before you dig, so buried utility lines are marked.
  2. Dig the hole a little deeper than the post depth and add 3 to 4 in of gravel for drainage.
  3. Set the post, check it is plumb on two sides and brace it.
  4. Fill with concrete, sloping the top away from the post so water runs off.
  5. Wait the time on the bag, often 24 to 48 hours, before attaching the box.

In cold climates, go below the frost line or at least 24 in deep so frost heave does not tilt the post. In loose soil, a wider hole adds stability. Some homeowners skip concrete and pack gravel firmly around the post instead, which drains better and makes replacing the post easier.

Frequently asked questions

How high should a mailbox be?

USPS asks for the bottom of the box 41 to 45 in above the road, with its front 6 to 8 in back from the curb.

How long should a mailbox post be?

For a box bottom 42 in high on a 2 in mount and 24 in in the ground, 64 in.

How deep should a mailbox post be buried?

About 24 in, or below the frost line in cold climates.

How much concrete for a mailbox post?

A 10 in hole 24 in deep around a 4 × 4 post takes about 0.92 cu ft, or 3 bags of 0.375 cu ft.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.