Skip to content
Omnikalc

How tall should a potting bench be?

Enter your height, how far below the elbow you want the worktop, the bench length and depth, the board width and the lower shelves: get the worktop height, the boards per layer, the decking length and the frame lumber.

Updated on
Your inputs
in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

in

Value out of range

Value out of range

Results

Worktop height

37 in

Decking boards

40 ft

Boards per layer
5
Frame lumber (legs and rails)
36 ft
Leave small gaps between slats so water and soil drain through, use rot-resistant or treated wood, and add a back rail so pots don't slide off

A potting bench gives you a comfortable place to sow seeds, repot plants and mix soil without bending over. Its most important dimension is height: too low and your back hurts, too high and your shoulders tire. This calculator suggests a worktop height from your own height and works out the boards and frame lumber.

How the calculation works

  • Elbow height ≈ 63% of your height
  • Worktop height = elbow height − the drop you want below the elbow
  • Boards per layer = bench depth ÷ board width, rounded up
  • Decking = boards per layer × (1 + lower shelves) × bench length
  • Frame lumber = 4 legs at worktop height + 2 × (length + depth) of rails per layer

For someone 69 in tall, the elbow is about 43.5 in from the floor. With the worktop 6 in below the elbow, the bench is about 37 in high. A 48 × 24 in bench with one lower shelf takes 5 boards of 5.5 in per layer, 40 ft of decking and about 36 ft of frame lumber.

Height for the job

Work Worktop below the elbow
Fine work: sowing, pricking out 2 to 4 in
General potting 4 to 6 in
Heavy work: mixing soil, big pots 6 to 10 in

If two people share the bench, set it for the taller one and keep a sturdy step or platform for the shorter one. Standing on gravel or a mat changes the height a little too.

Choosing the depth and length

A depth of 20 to 24 in lets you reach the back without stretching. A length of 4 ft suits most gardens; longer benches need a middle leg so the top does not sag under wet soil and heavy pots.

Useful features

  • Slatted top with small gaps so water and soil fall through.
  • Back rail or shelf for tools, seed packets and small pots.
  • Lower shelf for bags of compost, trays and watering cans.
  • Soil bin: a removable tray or a hole with a bin under it to sweep soil into.
  • Hooks on the sides for hand tools.

Wood and finish

Use cedar, larch, treated lumber or reclaimed pallet wood, and stainless or galvanized screws that do not rust. Keep the legs off wet ground with feet or pavers, and oil the top once a year if you want it to last. A zinc or plastic sheet on part of the top makes it easier to clean.

Frequently asked questions

How tall should a potting bench be?

About 4 to 6 in below your elbow: about 37 in for someone 69 in tall.

How deep should a potting bench be?

About 20 to 24 in, so you can reach the back without stretching.

How much wood for a 4 ft potting bench?

A 48 × 24 in bench with one lower shelf takes 5 boards of 5.5 in per layer, 40 ft of decking and about 36 ft of frame lumber.

Should a potting bench top have gaps?

Yes, small gaps between slats let water and soil fall through.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.