Skip to content
Omnikalc

Parking lot stall layout and count calculator

Enter the size of the lot, the size of a stall and the width of the aisle to get the stalls in a row, the number of rows, the total number of stalls and the accessible stalls.

Updated on
Your inputs
ft

Value out of range

ft

Value out of range

ft

Value out of range

ft

Value out of range

ft

Value out of range

Results

Total number of stalls

88

Stalls in each row
22
Rows of stalls
4
Accessible stalls required
4
Lot area per stall
340.9 ft²

The parking lot stall layout calculator gives the stalls in a row, the number of rows, the total number of stalls, the accessible stalls required and the lot area per stall, from the size of the lot, the size of a stall and the width of the aisle.

How the calculation works

  • Enter the length and the width of the lot.
  • Enter the width and the length of a stall and the width of the aisle.
  • The calculator finds the stalls in a row, the number of rows, the total number of stalls, the accessible stalls and the lot area per stall.

Example

A lot of 200 ft by 150 ft with stalls of 9 ft by 18 ft and an aisle of 24 ft has modules of 2 × 18 + 24 = 60 ft, two rows of stalls around one aisle. It holds 2 modules, and the 30 ft that remain are too narrow for one more row. Each row has 200 / 9 = 22 stalls, so the lot holds 22 × 4 = 88 stalls, of which 4 must be accessible, and it uses 340.9 ft² per stall.

Why it matters

The calculator helps developers, civil designers, contractors, property managers and planners to check how many stalls a site can hold, to compare the sizes of stalls and aisles, and to estimate the quantity of paving and striping for a lot before the final drawing.

Good to know

Draw the lot with the setbacks, the landscape strip and the entrance before you enter its size, because the usable area is smaller than the site. Test different widths of stall, since going from 9 ft to 8.5 ft adds about 5 percent of stalls. Keep the aisles straight, avoid dead ends, and slope the surface at 1 to 5 percent for drainage. Keep the accessible stalls near the entrance.

The parking ratio calculator gives the number of stalls that a building needs, the asphalt paver production calculator gives the output of a paver on a lot, the pavement marking paint quantity calculator gives the paint for the stripes and the garage size calculator gives the size of a home garage.

Frequently asked questions

How are the stalls laid out?

The calculator uses stalls at 90 degrees, in double rows that face each other across a two-way aisle. One module is two stall lengths plus one aisle width. The calculator fits as many full modules as possible across the width of the lot, then adds one single row against the edge if the remaining width holds a stall and an aisle. The stalls are counted along the length of the lot.

What sizes should I use for the stalls and the aisle?

A standard stall is 9 ft wide and 18 ft long, and the aisle of a 90 degree layout is 24 ft wide for two-way traffic. Many cities accept a narrower stall of 8.5 ft or a shorter one of 16 ft with an overhang, and some require 9.5 ft or more for a shopping center. The calculator lets you change all the dimensions, so enter the values of your zoning rules.

How many accessible stalls are required?

The ADA table sets the minimum number of accessible stalls from the total, which is 1 for up to 25 stalls, 2 for 26 to 50, 3 for 51 to 75, 4 for 76 to 100, 5 for 101 to 150 and 6 for 151 to 200. Above that the number grows slowly, and it reaches 2 percent of the stalls from 501 to 1,000. One in six of the accessible stalls must be van accessible, with a wider aisle beside them.

What does the calculator leave out?

The calculator takes a rectangular lot with no islands, no landscaping, no curb radius, no entrance, no drainage slope and no setbacks. It also does not include the stalls at an angle, the loading zones, the fire lanes or the stalls that are lost at the ends of the rows. Take about 10 percent off the count for a first estimate of a real lot, and draw the final plan.

Was this calculator helpful?

Thanks for your feedback!

Results are estimates provided for information purposes. They do not replace professional advice.